NEC SL 1000 Programming Manual page 240
Hide thumbs
Also See for SL 1000:
- Features and specifications manual (814 pages) ,
- Programming manual (666 pages) ,
- Hardware manual (150 pages)
Table of Contents
Advertisement
SL1000/SL1100
Item No.
10
Program
21
11
12
13
14
15
16
17
18
2-218
Downloaded from
www.Manualslib.com
Item
Dial Digits for Toll Restriction
Path
If this option is programmed with
an entry other than 0, a call does
not have a talk path unless the
user dials at least the number of
digits entered in this option when
placing an outgoing call.
This means that an entry of 4 or
higher in this program causes a
problem when dialing 911 (USA
only). Since it is only a 3-digit num-
ber, the call does not have a talk
path, preventing the emergency
dispatcher from hearing the caller.
This option should be kept at its
default setting of 0 to prevent any
problems with dialing 911 (USA
only).
Inter-Digit Time for Toll Restric-
tion Path Control
Dial E911 Routing Without Trunk
Access
If enabled (1), an extension user
can dial 911 (USA only) without
first dialing a trunk access code or
pressing a line key. If disabled (0),
an extension user must dial a trunk
access code (e.g., 9) or press a
line key before dialing 911 (USA
only).
Alarm Ring Timer (E911)
Use this option to set the duration
of the E911 Alarm Ring Time. If set
for 0, the E911 Alarm does not
ring.
Forced Account Code Inter-digit
Timer
The system waits this time for a
user to enter a Forced Account
code.
Outgoing Disable on Incoming
Line (Toll Restriction)
Enable or disable the Outgoing
Disable on Incoming Line feature.
Supervise Dial Detection Timer
With the Outgoing Disable on In-
coming Line feature, if dial tone is
not detected after the extension
answers an incoming line, the sys-
tem determines the call is unable
to complete and releases the
DTMF receiver.
Restriction Digit in Outgoing
Disable on Incoming Line
With the Outgoing Disable on In-
coming Line feature, determine the
number of digits to be dialed be-
fore the call should be discon-
nected.
Reset Dial After Failure of Trunk
Access
Enable (1) or Disable (0) the ability
to continue to dial codes or exten-
sions after receiving Trunk Busy.
This needs to be set to Enabled (1)
for the Forced Trunk Disconnect
feature to work.
manuals search engine
Input Data
0 ~ 36
0 ~ 60 seconds
0 = Trunk Access Code
Required
1 = Trunk Access Code
Not Required
0, 1~ 64800 seconds
(0 = Off)
0 ~ 64800 seconds
3 seconds
0 = Disable (Off)
1 = Enable (On)
0 ~ 64800 seconds
20 seconds
Digits 1 ~ 9
0 = Disable (Off)
1 = Enable (On)
Program 21 : Outgoing Call Setup
ISSUE 1.0
Default
Related Program
0
10
1
0
11-12-56
20-08-16
0
15-01-05
21-01-16
21-01-17
80-03-01
15-01-05
21-01-16
21-01-17
80-03-01
4
15-01-05
21-01-15
21-01-16
80-03-01
0
Hide quick links:
Advertisement
Table of Contents
