Active Image - Cisco 300 Series Administration Manual
Managed switch
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Quick start manual (72 pages) ,
- Datasheet (14 pages)
Table of Contents
Advertisement
4
Active Image
STEP 1
STEP 2
STEP 3
42
•
If SSH server authentication is not enabled, the operation succeeds for any
SCP server.
There are two firmware images stored on the device. One of the images is
identified as the active image and other image is identified as the inactive image.
The device boots from the image you set as the active image. You can change the
image identified as the inactive image to the active image. (You can reboot the
device by using the process described in the
only>
section).
To select the active image:
Click Administration > File Management > Active Image.
The page displays the following:
•
Active Image—Displays the image file that is currently active on the device.
•
Active Image Version Number—Displays the firmware version of the active
image.
•
Active Image After Reboot—Displays the image that is active after reboot.
•
Active Image Version Number After Reboot—Displays the firmware
version of the active image as it be after reboot.
Select the image from the Active Image After Reboot menu to identify the
firmware image that is used as the active image after the device is rebooted. The
Active Image Version Number After Reboot displays the firmware version of the
active image that is used after the device is rebooted.
Click Apply. The active image selection is updated.
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
Administration: File Management
Management Interface<print
Active Image
Advertisement
Table of Contents
