Chapter 1: Getting Started; Starting The Web-Based Configuration Utility - Cisco 300 Series Administration Manual

Managed switch

Hide thumbs Also See for 300 Series:

Table of Contents

Getting Started

Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)

This section provides an introduction to the web-based configuration utility, and

covers the following topics:

Starting the Web-based Configuration Utility

Quick Start Device Configuration

Interface Naming Conventions

Window Navigation

This section describes how to navigate the web-based switch configuration utility.

If you are using a pop-up blocker, make sure it is disabled.

Browser Restrictions

If you are using IPv6 interfaces on your management station, use the IPv6 global

address and not the IPv6 link local address to access the device from your

Launching the Configuration Utility

To open the web-based configuration utility:

Open a Web browser.

Enter the IP address of the device you are configuring in the address bar on the

browser, and then press Enter.