Advertisement
Quick Links
BH79D212H02
CYLINDER UNIT OPTIONAL PARTS
IMMERSION HEATER (1Ph 3kW)
PAC-IH03V-E
INSTALLATION MANUAL
● Before starting installation, read the following description together with the installation manual included with the cylinder unit.
● Please read carefully and observe fully the following safety precautions.
WARNING
Precaution that must be observed to prevent injuries or death.
●
After installation carry out a test run to ensure correct operation, then explain operation method and safety precautions to the
end user.
Tell your customers to keep this installation manual together with the operation manual, and when they give or sell this
machine to any other person include this installation manual and operation manual with it.
WARNING
●
If the cylinder has already been connected to the power supply ensure circuit breaker is off before carrying out electrical
work.
●
If the immersion heater is installed incorrectly or modified after installation by the user water leakage, electric shock or
fire may result.
●
All electrical work should be performed by a qualified technician according to local regulations and the instructions given
in this manual.
●
The immersion heater must be powered by a dedicated power supply and the correct voltage and correctly sized circuit
breakers must be used.
●
Connections must be made securely and without tension on the terminals.
The included component parts of the PAC-IH03V-E IMMERSION HEATER (1Ph 3kW) shall be used only for the purposes
indicated in the installation manual.
Contents
Item
Piece
Immersion heater
1
Thermostat (High limit thermal cut-out)
1
Tab cover
1
Earth leakage breaker
1
Screw (4×25)
2
Relay
1
Screw (4×16)
2
Label (for Earth leakage breaker)
1
Label (for Relay)
1
Lead wire with connector
1
Lead wire (Red, 100mm)
1
Lead wire (Blue, 100mm)
1
Lead wire (Red, 1500mm)
1
Lead wire (Blue, 1500mm)
1
Water-proof cover
1
Water-proof seal (3x35x25)
1
Water-proof seal (3x40x25)
1
Band
1
Tool
1
Installation manual
1
Advertisement
Related Manuals for Mitsubishi Electric PAC-IH03V-E
Summary of Contents for Mitsubishi Electric PAC-IH03V-E
- Page 1 The immersion heater must be powered by a dedicated power supply and the correct voltage and correctly sized circuit breakers must be used. ● Connections must be made securely and without tension on the terminals. The included component parts of the PAC-IH03V-E IMMERSION HEATER (1Ph 3kW) shall be used only for the purposes indicated in the installation manual.
- Page 2 BH79D212H02 Check before starting installation that no water is in the tank. Diagonally locate the thermostat pockets on upper Reinstate plastic tab cover over right and bottom left with termini on the upper left the connectors then insert the and bottom right sides as shown. thermostat rod into the upper Secure tightly with the nut to prevent water leakage.