Table of Contents
Advertisement
Chapter 4
Maintaining and Troubleshooting the ISDN System
Checking the Status of a Trunk Termination
Trunk group state for FAS: ISDN D-Channel delete graceful.
Step 7
The following command indicates you are waiting for calls to finish before going to out-of-service. If
the wait time is too long, you can control the trunk group with mode=forced.
control isdn-dchan id=xxxx; mode=graceful; target-state=oos;dchan-type=<primary | backup>
Checking the Status of a Trunk Termination
Check the status of a trunk termination using the following command:
status trunk-termination tgn-id=<trunk group number>;cic=<cic number>;
Reply : Success:
TGN_ID -> 100
CIC -> 8
RESULT -> ADM configure result in success
REASON -> ADM executed successfully
TERM_ADMIN_STATE -> ADMIN_INS
TERM_OPER_STATE -> Term is available for new calls
TERM_REASON -> No fault reason available
TRUNK_STATIC_STATE -> ACTV
TRUNK_DYNAMIC_STATE -> IDLE
TRUNK_REASON -> NON_FAULTY
Reply : Success: at 2007-01-03 15:41:32 by btsadmin
Entry 1 of 1 returned.
The above status shows that the trunk is active, in idle mode, and ready for call use.
If the trunk static state is set to locally blocked, go to the
"Trunk Static State Is Set to Locally Blocked"
section.
If the trunk static state is set to TRNS, go to the
"Trunk Static State Is Set to TRNS"
section.
If the trunk static state is set to remotely blocked, go to the
"Trunk Static State Is Set to RBLK"
section.
If the trunk static state is set to TERM_STATUS_FAULTY, go to the
"Termination Status Is Faulty"
section.
If the trunk static state returns Cannot Make Call, go to the
"Cannot Make a Call"
section.
Cisco BTS 10200 Softswitch ISDN Provisioning and Troubleshooting
4-7
OL-12436-02
Advertisement
Table of Contents
