– avoid open flames and sources of ignition themselves into it. – thoroughly ventilate the room in which the • If this appliance featuring magnetic door appliance is situated seals is to replace an older appliance having www.zanussi.com...
Page 3
(If the appli- catching warm parts (compressor, condens- ance is Frost Free) er) to prevent possible burn. • Frozen food must not be re-frozen once it has been thawed out. www.zanussi.com...
The materials used on this appliance marked by ized Service Centre, and only genuine spare the symbol are recyclable. parts must be used. Product description Fruit drawers Bottle rack Glass shelf Glass shelf Glass shelf Control unit Glass shelf Butter shelf www.zanussi.com...
Cleaning the interior with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new Before using the appliance for the first time, product, then dry thoroughly. wash the interior and all internal accessories www.zanussi.com...
Small pieces may even be cooked still frozen, position as required. directly from the freezer: in this case, cooking will take longer. www.zanussi.com...
• lean foods store better and longer than fatty Fruit and vegetables: these should be thor- ones; salt reduces the storage life of food; oughly cleaned and placed in the special draw- er(s) provided. www.zanussi.com...
"no frost" type. This means that Many proprietary kitchen surface cleaners con- there is no buildup of frost when it is in opera- tain chemicals that can attack/damage the plastics used in this appliance. For this reason www.zanussi.com...
Water flows into the refrig- The water outlet is clogged. Clean the water outlet. erator. Products prevent that water flows Make sure that products do not into the water collector. touch the rear plate. www.zanussi.com...
Location appliance: The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure www.zanussi.com...
Page 11
Warning! This appliance must be earthed. 1. Release the screw. The manufacturer declines any liability 2. Engage the spacer below the screw. should these safety measures not be observed. 3. Turn the spacer to the right position. 4. Tighten again the screws. www.zanussi.com...
Page 12
1. Connect the wire coloured green and yel- low to the terminal marked either with the letter “E“ or by the earth symbol or col- oured green and yellow. www.zanussi.com...
By ensuring this product household waste disposal service or the shop is disposed of correctly, you will help prevent where you purchased the product. www.zanussi.com...