Using Express Setup - Cisco Catalyst 3750 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 3750:
- Command reference manual (1154 pages) ,
- Software configuration manual (926 pages) ,
- Hardware installation manual (150 pages)
Table of Contents
Advertisement
Using Express Setup
Express Setup is a browser-based program that you can use to set up and configure
the switch. You assign the IP information so that the switch can connect to local
routers and the Internet. The IP address is also required if you plan to further
configure the switch. This chapter provides an Express Setup procedure for a
standalone switch.
Express Setup is supported on switches running Cisco IOS Release 12.1(14)EA1
or later. When you are installing a switch, refer to the Cisco IOS release label on
the rear panel of the switch to determine the software release.
For setup instructions using the CLI-based setup program, go to
"Configuring the Switch with the CLI-Based Setup Program."
Before connecting the switch to a power source, review the safety warnings in
Note
Chapter 3, "Switch Installation."
The setup procedure includes these steps:
•
•
•
•
•
78-15136-03
Taking Out What You Need, page 1-3
Powering On the Switch, page 1-4
Starting Express Setup, page 1-5
Configuring the Switch, page 1-11
Where to Go Next, page 1-14
C H A P T E R
Catalyst 3750 Switch Hardware Installation Guide
1
Appendix C,
1-1
Advertisement
Table of Contents
Troubleshooting
