Cisco ASR 1002 Hardware Installation Manual page 53

Asr 1000 series

Hide thumbs Also See for ASR 1002:

Table of Contents

Cisco ASR 1002 Router Overview and Installation

Step 9

After inserting the ground wire, leave an extra service loop in the ground lead to ensure that the ground lead is the last

lead to disconnect from the power supply if a great deal of strain is placed on all three leads as shown in the following

image.

Figure 35: Cisco +24 VDC Power Supply Terminal Block Ground Lead Service Loop

Step 10

After tightening the receptacle screw for the ground, and leaving the extra service loop in the ground lead, use a cable

tie to secure the three leads to the power supply faceplate tie-wrap tab as shown in the above imave, item 5.

Step 11

Turn on the branch source breaker.

Step 12

Place the power supply standby switch to the On (|) position. The power supply LEDs light when power is supplied to

the router.

What to Do Next

This completes the steps for installing the +24 VDC power supply in the Cisco ASR 1002 Router.

Ground lead wire with

service loop

Negative lead wire

Positive lead wire

Cisco ASR 1000 Series Router Hardware Installation Guide

Connecting Cisco 24 VDC Power Supply

—

+24 VDC power supply

Standby switch

Power supply tabs

—

Table of Contents