Removing An Interface Module - Cisco ASR 902 Installation Manual

Hide thumbs Also See for ASR 902:

Table of Contents

Installing the Cisco ASR 902 Router

Removing an Interface Module

Step 1

To remove an interface module, disconnect all the cables from each interface module.

Step 2

Loosen the locking thumbscrews on both sides of the interface module.

Step 3

Slide the interface module out of the router slot by pulling on the handles. If you are removing a blank filler plate, pull

the blank filler plate completely out of the router slot using the captive screws.

Hot-Swapping an Interface Module

The Cisco ASR 902 Router provides a feature that allows you to remove and replace an interface module

without powering down the router. This feature, called hot-swapping or Online Insertion and Removal (OIR),

allows you to remove and replace a redundant module without disrupting router operation.

The Cisco ASR 902 Router does not support hot-swapping an interface module with another module of

Note

a different type. For example, you cannot swap an SFP Gigabit Ethernet module with a copper Gigabit

Ethernet module without disrupting router operation.

Note

If you perform OIR on an interface module and move the module to a different slot, the router does not

retain the module configuration; you must reconfigure the interface module.

When you remove or insert a redundant module while the router is powered on and running, the router does

the following:

1 Determines if there is sufficient power for the module.

2 Scans the backplane for configuration changes.

3 Initializes the newly inserted module. In addition, the system notes any removed modules and places those

modules in the administratively shutdown state.

4 Places any previously configured interfaces on the module back to the state they were in when they were

removed.

The router runs diagnostic tests on any new interfaces and the test results indicate the following:

• If the tests are successful it means the router is operating normally.

• If the new module is faulty, the router resumes normal operation, but leaves the new interfaces disabled.

• If the diagnostic tests fail, the router stops operating, which usually indicates that the new module has

a problem in the bus and should be removed.

Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide

Removing an Interface Module

Table of Contents