Huawei TE40 Administrator's Manual page 71
Videoconferencing endpoint
Hide thumbs
Also See for TE40:
- User manual (48 pages) ,
- Quick installation manual (7 pages) ,
- Operation manual (51 pages)
Table of Contents
Advertisement
HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Indicator Status
The Wi-Fi indicator is blinking red.
The battery indicator is off.
The battery indicator is steady red.
The charging status indicator is blue and is
in breathing state.
The charging status indicator is steady
blue.
The charging status indicator is off.
For more information, see the HUAWEI VPM220W Microphone Array V100R001 Quick Start
Guide and HUAWEI VPM220W Microphone Array V100R001 User Guide.
Connecting the VPM220W to the Endpoint
TThe endpoint can be connected over a Wi-Fi network to a VPM220W for sound pickup.
Before connecting the VPM220W to the endpoint, you must enable the Wi-Fi hotspot and set
Wi-Fi parameters as follows:
For details, see
To connect the VPM220W to the endpoint:
Step 1 Press the power button at the bottom of the VPM220W to power it on.
The VPM220W automatically searches for an available Wi-Fi network.
Step 2 Hold and press the button on top of the VPM220W for at least 3 seconds.
A confirmation dialog box is displayed on the remote controlled UI.
Step 3 Select OK.
Issue 01 (2013-09-30)
Set Identity authentication mode to WPA-PSK or WPA2-PSK.
Enable DHCP and set Start IP address and End IP address.
Setting Wi-Fi Hotspot
If the VPM220W was once connected to the endpoint, the connection between these two
will automatically set up, so you can skip the following steps.
If you are using the VPM220W for the first time or moving it outside the connected
Wi-Fi network range, go to
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VPM220W Work Status
the Wi-Fi signal is weak.
The VPM220W is searching for Wi-Fi
hotspots.
The battery level is sufficient (the battery
can run another 30 minutes or more).
The VPM220W is powered off.
The battery level is insufficient (the battery
can run less than 30 minutes).
The VPM220W is being recharged.
The VPM220W is fully charged.
The VPM220W is not placed on the
charger base.
The VPM200W's power adapter is not
connected to an AC power supply.
Parameters.
Step 2
and
Step
3.
5 Microphone and Speaker
63
Advertisement
Table of Contents
Troubleshooting
