Cisco Catalyst 2960-X Hardware Installation Manual page 7

Hide thumbs Also See for Catalyst 2960-X:

Table of Contents

Switch Installation

• Make sure that you have access to the switch rear panel and to the rear of the rack.

Installing a FlexStack-Plus or a FlexStack-Extended Module

Note

The switch should always have a blank module installed when a FlexStack module is not used.

The Catalyst 2960X-48P-L switch is shown as an example. You can install the module in other switches as

shown.

Procedure

Step 1

Use a number 2 Phillips-head screwdriver to remove the FlexStack module blank cover on the switch back

panel.

Step 2

Grasp the FlexStack module on the sides, and insert it into the module slot. Push the module in completely

until you feel it snap into place.

The following example image uses FlexStack-Plus module.

OL-28309-02

◦ CAB-STK-E-3M= (3-meter cable)

Installing a FlexStack-Plus or a FlexStack-Extended Module

Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide

Table of Contents

Show Quick Links

Table of Contents

Catalyst 2960-xr