Cisco Catalyst 2960-X Hardware Installation Manual page 22

Hide thumbs Also See for Catalyst 2960-X:

Table of Contents

Connecting FlexStack-Extended modules (Optional)

Procedure

Step 1

Remove the dust covers from the FlexStack cables, and store them for future use.

Step 2

Insert one end of the FlexStack cable into the stack port of the first switch. Insert the other end of the cable

into the stack port on the other switch. Make sure that you insert the cables in completely until you feel them

snap into place.

Note

Step 3

Replace the dust covers when you remove the FlexStack cables from the connectors.

Caution

Connecting FlexStack-Extended modules (Optional)

Always use a Cisco-approved FlexStack cable to connect the switches.

This is only supported on the stack-capable switches.

Note

Catalyst 2960-X and 2960-XR Switch Hardware Installation Guide

When you connect the FlexStack cable to the STACK 1 port, the tab should be above the connector.

When you connect the FlexStack cable to the STACK 2 port, the tab should be below the connector.

Removing and installing the FlexStack cable can shorten its useful life. Do not remove and insert

the cable more often than is absolutely necessary.

Switch Installation

OL-28309-02

Table of Contents

Show Quick Links

Table of Contents

Catalyst 2960-xr