Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
DETAILED STEPS
Command or Action
Step 1
config
Example:
RP/0/0/CPU0:router# configure
Step 2
iphc tcp connections max-number location node-id
Example:
RP/0/0/CPU0:router(config)# iphc tcp connections
2000 location 0/1/cpu0
Step 3
iphc non-tcp connections max-number location
node-id
Example:
RP/0/0/CPU0:router(config)# iphc non-tcp
connections 20000 location 0/1/cpu0
Step 4
end
or
commit
Example:
RP/0/0/CPU0:router(config-if)# end
or
RP/0/0/CPU0:router(config-if)# commit
OL-26061-03
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
How to Configure Serial Interfaces
Purpose
Enters global configuration mode.
Sets the maximum number of TCP connections that
may be configured for IPHC on a line card.
The range is 1 to 2000.
Sets the maximum number of non-TCP connections
that may be configured for IPHC on a line card.
The range is 1 to 20000.
Saves configuration changes.
When you issue the end command, the system
•
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting (yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to
–
the running configuration file, exits the
configuration session, and returns the router
to EXEC mode.
Entering no exits the configuration session
–
and returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the
–
current configuration session without exiting
or committing the configuration changes.
Use the commit command to save the
•
configuration changes to the running
configuration file and remain within the
configuration session.
535