Connecting The System Cables - Cisco ASR 1013 Installation Manual

Hide thumbs Also See for ASR 1013:

Hardware installation manual (702 pages)

Quick start manual (37 pages)

Replacing (120 pages)

Table of Contents

Cisco ASR 1013 Router Overview and Installation

The following image shows the Cisco ASR 1000 Series route processor console port connectors.

Figure 18: Cisco ASR 1000 Series Route Processor Console Port Connectors

SUMMARY STEPS

1. Connect one end of the RJ-45 cables to the serial RJ-45 port (CON) on the Cisco ASR1000-RP2 route

processor.

2. Run the cable up and through the cable-management bracket and connect the other end of the RJ-45 cable

to the RJ-45 adapter,

3. Connect the adapter to your video terminal to complete the cable connection.

4. Power on your video terminal.

5. Configure your video terminal to match the following default console port settings: 9600 baud, 8 data bits,

No parity generation or checking, 1 stop bit, and No flow control.

6. Go to the

DETAILED STEPS

Step 1

Connect one end of the RJ-45 cables to the serial RJ-45 port (CON) on the Cisco ASR1000-RP2 route processor.

Step 2

Run the cable up and through the cable-management bracket and connect the other end of the RJ-45 cable to the RJ-45

adapter,

Step 3

Connect the adapter to your video terminal to complete the cable connection.

Step 4

Power on your video terminal.

Step 5

Configure your video terminal to match the following default console port settings: 9600 baud, 8 data bits, No parity

generation or checking, 1 stop bit, and No flow control.

Step 6

Go to the

Connecting the System Cables, on page 39