Prerequisites And Preparation; Safety Guidelines - Cisco 10008 Installation And Configuration Manual
Pre4
Hide thumbs
Also See for 10008:
- Quick start manual (49 pages) ,
- Hardware installation manual (172 pages) ,
- Software configuration manual (624 pages)
Table of Contents
Advertisement
Table 3
Message
IOS STRT, IOS EXC, IOS FPGA, IOS
FPOK, IOS FILE, IOS STBY, IOS INTF,
IOS MEM, IOS DRVR, IOS LIB, IOS
MGMT, IOS PROT, IOS CONF
IOS RUN
IOS STBY
Prerequisites and Preparation
Before you perform any of the procedures in this guide, we recommend that you:
•
•
•
•
The following publications can be used as reference material while performing procedures in this
document:
Safety Guidelines
Before you begin the PRE4 installation procedure, review the safety guidelines in this section to avoid
injuring yourself or damaging the equipment. Before you install, configure, or perform maintenance on
the router, you should also review the safety warnings listed in the
Information for the Cisco 10000 Series Routers
OL-13840-01
Messages on PRE4 Alphanumeric Display
Read the safety guidelines in the next section and review the electrical safety and ESD-prevention
guidelines as described in the Cisco 10008 Router Hardware Installation Guide at the following url:
http://cisco.com/en/US/docs/routers/10000/10008/install_and_upgrade/hardware_installation/
guide/8-hig.html
Ensure that the software configuration meets the minimum requirements for the installation (see the
"Software Compatibility" section on page
Ensure that you have all of the necessary tools and equipment before beginning the installation (see
the
"Installation Guidelines" section on page
Have a terminal console connected to the PRE4 to configure the PRE4 after it is installed.
–
Cisco 10000 Series Router Performance Routing Engine Installation at:
http://cisco.com/en/US/products/hw/routers/ps133/
prod_installation_guide09186a0080525aba.html
Cisco 10000 Series Internet Router Troubleshooting Guide at:
–
http://cisco.com/en/US/products/hw/routers/ps133/
prod_troubleshooting_guide_book09186a00807a1043.html
PRE4 Status
These messages appear in quick succession during the
boot process.
[On the primary PRE4] The PRE4 has finished booting
and is running Cisco IOS. This is the normal operating
status for the primary PRE.
[On the secondary PRE4] The PRE4 is in standby mode
and ready to take over if the primary PRE4 fails. This is
the normal operating status for the secondary PRE4.
8).
8).
Regulatory Compliance and Safety
document.
Cisco 10008 Router PRE4 Installation and Configuration Guide
Prerequisites and Preparation
7
- Quick Links:
- Product Overview
- Installation Guidelines
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
