C H A P T E R 15 Configuring The 8-Port Channelized T1/E1 Spa - Cisco ASR 1000 Configuration Manual
Aggregation services routers sip and spa software
Hide thumbs
Also See for ASR 1000:
- Software configuration manual (602 pages) ,
- Configuration manual (126 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Configuration Tasks
•
•
To better understand the address format used to specify the physical location of the SIP, SPA, and
Note
interfaces, see the
Setting the Card Type
The SPA is not functional until the card type is set. Information about the SPA is not indicated in the
output of any show commands until the card type has been set. There is no default card type.
Mixing of interface types is not supported. All ports on a SPA must be of the same type.
Note
To set the card type for the 8-Port Channelized T1/E1 SPA, complete these steps:
Command
Step 1
Router# configure terminal
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
15-2
Setting the IP Address, page 15-6
Verifying Interface Configuration, page 15-6
"Specifying the Interface Address on a SPA" section on page
Chapter 15
Configuring the 8-Port Channelized T1/E1 SPA
Purpose
Enters global configuration mode.
15-6.
OL-14127-08
- Quick Links:
- Configuring a Subinterface on a Vlan
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
