Configuring Multiple Bgp Instances For A Specific Autonomous System - Cisco ASR 9000 Series Routing Configuration Manual
Aggregation services router
Hide thumbs
Also See for ASR 9000 Series:
- Command reference manual (1138 pages) ,
- Reference manual (696 pages) ,
- Configuration manuallines (694 pages)
Table of Contents
Advertisement
Implementing BGP
Command or Action
Step 7
bgp router-id ip-address
Example:
RP/0/RSP0/CPU0:router(config-bgp)# bgp router-id
192.168.70.24
Step 8
address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RSP0/CPU0:router(config-bgp)# address-family
ipv4 unicast
Step 9
exit
Example:
RP/0/RSP0/CPU0:router(config-bgp-af)# exit
Step 10
neighbor ip-address
Example:
RP/0/RSP0/CPU0:router(config-bgp)# neighbor
172.168.40.24
Step 11
remote-as as-number
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# remote-as
2002
Step 12
address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)#
address-family ipv4 unicast
Step 13
route-policy route-policy-name { in | out }
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)#
route-policy drop-as-1234 in
Step 14
commit
Configuring Multiple BGP Instances for a Specific Autonomous System
Perform this task to configure multiple BGP instances for a specific autonomous system.
Configuring Multiple BGP Instances for a Specific Autonomous System
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
Purpose
Configures the local router with a specified router ID.
Specifies either the IPv4 or IPv6 address family and
enters address family configuration submode.
To see a list of all the possible keywords and arguments
for this command, use the CLI help (?).
Exits the current configuration mode.
Places the router in neighbor configuration mode for
BGP routing and configures the neighbor IP address as
a BGP peer.
Creates a neighbor and assigns a remote autonomous
system number to it.
Specifies either the IPv4 or IPv6 address family and
enters address family configuration submode.
To see a list of all the possible keywords and arguments
for this command, use the CLI help (?).
(Optional) Applies the specified policy to inbound IPv4
unicast routes.
81
- Quick Links:
- Prefix-Set
Hide quick links:
Advertisement
Table of Contents
