hit counter script
Kenwood NXR-700 Instruction Manual
  1. Manuals
  2. Brands
  3. Kenwood Manuals
  4. Repeater
  5. NEXEDGE NXR-700
  6. Instruction manual
Kenwood NXR-700 Instruction Manual

Kenwood NXR-700 Instruction Manual

Vhf digital base-repeater/ uhf digital base-repeater
Hide thumbs Also See for NXR-700:
1
2
3
4
5
6
7

Advertisement

Table of Contents

See also: Service Manual , Instruction Manual
NXR-700/ NXR-800
VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER
INSTRUCTION MANUAL
BASE-REPETIDOR DIGITAL VHF / BASE-REPETIDOR DIGITAL UHF
MANUAL DE INSTRUCCTIONES
BASE-RELAIS NUMÉRIQUE VHF/BASE-RELAIS NUMERIQUE UHF
MODE D'EMPLOI
© B62-1994-00 (K, K2)
09 08 07 06 05 04 03 02 01 00

Advertisement

Table of Contents
loading

Related Manuals for Kenwood NXR-700

Summary of Contents for Kenwood NXR-700

  • Page 1 NXR-700/ NXR-800 VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER INSTRUCTION MANUAL BASE-REPETIDOR DIGITAL VHF / BASE-REPETIDOR DIGITAL UHF MANUAL DE INSTRUCCTIONES BASE-RELAIS NUMÉRIQUE VHF/BASE-RELAIS NUMERIQUE UHF MODE D'EMPLOI © B62-1994-00 (K, K2) 09 08 07 06 05 04 03 02 01 00...

  • Page 2: Unpacking And Checking Equipment

    ◆ Illegal operation is punishable by fine and/or imprisonment. Please consult your dealer for installing the repeater and ◆ Refer service to qualified technicians only. antenna. MICROPHONE INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC Connect an optional KMC-30, KMC-35, or KMC-9C Kenwood This equipment has been tested and found to comply with the limits microphone to the MICROPHONE jack on the front panel. for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful...

  • Page 3: Controls And Functions

    CONTROLS AND FUNCTIONS ■ Front Panel STATUS 3 4 5 6 7 8 VOLUME MON TAKE OVER DISABLE CTRL OCXO BUSY POWER MICROPHONE OFF/ q Speaker TX indicator Lights red while transmitting. w CH/STATUS Display Two 17-segment digits display the channel number, name, !0 BUSY indicator or status. Lights green while a signal is being received. STATUS indicator !1 OCXO indicator Indicates the status of the repeater.
  • Page 5 TERMINAL MIC(Modular Jack) Pin Number Pin Name Description Specification notes Power Output 13.8V PTT Signal Input Impeadance 100kΩ MICG MIC GND MIC GND MIC Input 600Ω HOOK Hook Detection Input Impeadance 100kΩ COM (D-SUB 9Pin) CONNECTOR Pin Name Pin Number Description Specification notes...
  • Page 6 Control I/O (D-SUB 25Pin) CONNECTOR Pin Name Pin Number Description Specification notes Programmable Function Input 1 Input Impeadance 47kΩ Programmable Function Input 2 Input Impeadance 47kΩ Programmable Function Input 3 Input Impeadance 47kΩ Digital GND TX Audio Input Input Impeadance 600Ω not Pre-emphasis TX Audio Input Input Impeadance 600Ω...

  • Page 7: Mandatory Safety Instructions To Installers And Users

    MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND USERS • Use only manufacturer or dealer supplied antenna. • Antenna Minimum Safe Distance: 60 cm (2 feet), 50% duty Cycle. • Antenna Gain: 0 dBd referenced to a dipole. The Federal Communications Commission has adopted a safety standard for human exposure to RF (Radio Frequency) energy which is below the OSHA (Occupational Safety and Health Act) limits.

This manual is also suitable for:

Nxr-800

Table of Contents