Checking Your System Settings; Resetting The System; Default System Settings - Pioneer VSX-82TXS Operating Instructions Manual
Audio/video multi-channel receiver
Hide thumbs
Also See for VSX-82TXS:
- Service manual (10 pages) ,
- Service manual (324 pages) ,
- Service manual (72 pages)
Table of Contents
Advertisement
Using other functions
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
AUDIO SUBTITLE
DISP
STATUS
SIGNAL SEL
MULTI OPE
THX
SHIFT
PHASE
1
Press STATUS to check the system settings.
These appear on both the OSD and the front panel
1
display.
STATUS
96kHz
STEREO
Signal Select
SBch Processin : OFF
Retriever
Video Select
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3
The front panel display shows each of the following
settings for two seconds each:
Input source
Signal select
Sound Retriever
MCACC Position
Room 3
2
When you're finished, press STATUS again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the front panel AV
PARAMETER button, press and hold
for about three seconds.
The display shows RESET?.
3
Press the front panel ENTER button.
The display shows RESET OK?.
4
Press SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Note
1 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
HDD
DVD
CH
CH
PHOTO
SBch
STEREO
STANDARD
ADV. SURR
MCACC
S.DIRECT
: AUTO
: ON
: OFF
: SOURCE
Listening mode
Surround Back Processing
Video Select
Room 2 / REC SEL
STANDBY/ON
Default system settings
Setting
HDMI Audio
Digital Video Conversion
Speakers
Surround Back System
Speaker System
Front
Center
Surr.
SB
SW
Crossover
Bass Peak Level
X-Curve
THX Audio Setting
Inputs
See Input function default and possible settings on page 64.
Multi Room
Room 2 Volume Type
Room 2 Volume
SR+
SR+ Control On/Off
SR+ Volume Control On/Off
Monitor Out
DSP
MCACC Position Memory
Surround back channel
Processing
Phase Control
Sound Retriever
Sound Delay
Dual Mono
DRC
SACD Gain
Digital Safety
Effect Level
7 ch Stereo
Other modes
10
Default
Amp
On
A
Normal (SBch)
SMALL
SMALL
SMALL
SMALLx2
YES
80 Hz
OFF
OFF
0–1ft.
Variable
-60
OFF
OFF
OFF
M1: MEMORY 1
ON
On
Off
0 frame
CH1
OFF
0 dB
OFF
90
50
69
En
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
