Table of Contents
Advertisement
• This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a
recreational vehicle, truck, or bus, check the battery voltage.
• To avoid shorts in the electrical system, be sure to disconnect the
installation.
• Refer to the owner's manual for details on connecting the power amp and other units, then make
connections correctly.
• Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and
seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of
the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body.
• Don't pass the yellow lead through a hole into the engine compartment to connect to the battery.
This will damage the lead insulation and cause a very dangerous short.
• Do not shorten any leads. If you do, the protection circuit may fail to work when it should.
• Never feed power to other equipment by cutting the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating.
• When replacing fuse, be sure to use only fuse of the rating prescribed on this unit.
• Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded
or the left and right
• Speakers connected to this unit must be high-power types with minimum rating of 40 W and
impedance of 4 to 8 ohms. Connecting speakers with output and/or impedance values other than those
noted here may result in the speakers catching fire, emitting smoke or becoming damaged.
• When this product's source is switched ON, a control signal is output through the blue/white lead.
Connect to an external power amp's system remote control or the car's Auto-antenna relay control
terminal. (Max. 300 mA 12 V DC.) If the car features a glass antenna, connect to the antenna booster
power supply terminal.
• When an external power amp is being used with this system, be sure not to connect the blue/white
lead to the amp's power terminal. Likewise, do not connect the blue/white lead to the power terminal
of the auto-antenna. Such connection could cause excessive current drain and malfunction.
• To avoid short-circuiting, cover the disconnected lead with insulating tape. Especially, insulate the
unused speaker leads without fail. There is a possibility of short-circuiting if the leads are not
insulated.
speaker leads are common.
battery cable before beginning
Hide quick links:
Advertisement
Table of Contents
