hit counter script

Beacon Led - Cisco Catalyst 9300 Series Hardware Installation Manual

Hide thumbs Also See for Catalyst 9300 Series:
Table of Contents

Advertisement

LEDs
Port Mode
STACK (stack
member)
3
PoE+
3 Only switches with PoE or PoE+ ports.

Beacon LED

The UID and the Beacon LED can be turned on by the administrator to indicate that the switch needs attention.
It helps the administrator identify the switch. The beacon can be turned on by either pressing the UID button
on the switch front panel, or by using the CLI. There is a blue beacon on the front and rear panel of the switch.
The blue beacon on the front panel is a button labeled UID, and on the back panel it is a LED labeled BEACON.
Color/State
Solid blue
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
12
Port LED Color
Meaning
Off
No stack member corresponding to that member number.
Blinking green
Stack member number.
Green
Member numbers of other stack member switches.
Off
PoE+ is off.
If the powered device is receiving power from an AC
power source, the port LED is off even if the device is
connected to the switch port.
Green
PoE+ is on. The port LED is green when the switch port
is providing power.
Alternating green-amber
PoE+ is denied because providing power to the powered
device will exceed the switch power capacity.
Blinking amber
PoE+ is off due to a fault or because it has exceeded a
limit set in the switch software.
Caution
Amber
PoE+ for the port has been disabled.
Note
PoE+ faults occur when noncompliant cabling
or powered devices are connected to a PoE+
port. Use only standard-compliant cabling to
connect Cisco prestandard IP Phones and
wireless access points or IEEE
802.3af-compliant devices to PoE+ ports. You
must remove from the network any cable or
device that causes a PoE+ fault.
PoE+ is enabled by
default.
Description
The operator has indicated that the system needs
attention.
Product Overview

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF