Connecting To Sfp Modules; Connecting To Fiber-Optic Sfp Modules - Cisco Catalyst 3560 Hardware Installation Manual
Hide thumbs
Also See for Catalyst 3560:
- Getting started manual (37 pages) ,
- Software configuration manual (892 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Connecting to SFP Modules
Connecting to SFP Modules
Connecting to Fiber-Optic SFP Modules
Caution
Step 1
Step 2
Step 3
Step 4
Catalyst 3560 Switch Hardware Installation Guide
3-32
This section describes how to connect to SFP modules. For instructions on how to
connect to fiber-optic SFP modules, see the
Modules"
section. For instructions on how to connect to copper 1000BASE-T SFP
modules, see the
"Connecting to 1000BASE-T SFP Modules"
For instructions about how to install or remove an SFP module, see the
and Removing SFP Modules" section on page
Follow these steps to connect a fiber-optic cable to an SFP module:
Do not remove the rubber plugs from the SFP module port or the rubber caps from
the fiber-optic cable until you are ready to connect the cable. The plugs and caps
protect the SFP module ports and cables from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and
cabling stipulations in the
"SFP Module Slots" section on page
Specifications,"
for information about the LC on the SFP module.
Remove the rubber plugs from the module port and fiber-optic cable, and store
them for future use.
Insert one end of the fiber-optic cable into the SFP module port (see
Insert the other cable end into a fiber-optic connector on a target device.
Observe the port status LED.
The LED turns green when the switch and the target device have an established
link.
The LED turns amber while the STP discovers the network topology and searches
for loops. This process takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable
problem, or there might be problem with the adapter installed in the target device.
See
Chapter 4, "Troubleshooting,"
"Connecting to Fiber-Optic SFP
3-24.
"Installation Guidelines" section on page 3-8
2-7. See
Appendix B, "Connector and Cable
for solutions to cabling problems.
Chapter 3
Switch Installation
section.
"Installing
and in the
Figure
3-18).
78-16057-01
Advertisement
Table of Contents
