Iscsi Enable Module - Cisco MDS 9000 series Command Reference Manual
Hide thumbs
Also See for MDS 9000 series:
- Configuration manual (344 pages) ,
- Troubleshooting manual (161 pages) ,
- Hardware installation manual (60 pages)
Table of Contents
Advertisement
Chapter 11
I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iscsi enable module
To enable iSCSI features for each IPS linecard to create corresponding iSCSI interfaces, use the iscsi
enable module command.
Syntax Description
module-num
Defaults
iSCSI interfaces are disabled on IPS linecards by default.
Command Modes
Configuration mode.
Command History
Release
3.2(1)
Usage Guidelines
None.
Examples
The following example shows how to enable the iSCSI interface on a desired module number on the
switch.
switch# config
Enter configuration commands, one per line.
switch(config)# iscsi enable module 1
The iSCSI feature must be enabled before executing this command.
Note
Related Commands
Command
iscsi enable
OL-8413-07, Cisco MDS SAN-OS Release 3.x
iscsi enable module module-num
Specifies the desired IPS linecard module number on which iSCSI interfaces
need to be enabled.
Modification
This command was introduced.
Description
Enables the iSCSI features but does not create the interfaces.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
iscsi enable module
11-85
Advertisement
Table of Contents
