Yamaha CL5 Reference Manual page 9
Digital
Hide thumbs
Also See for CL5:
- Reference manual (261 pages) ,
- Owner's manual (67 pages) ,
- Supplementary manual (26 pages)
Table of Contents
Advertisement
When using Surround mode (MIX1- MIX6)
3
DOWN MIX
This field enables you to view the downmix
coefficient and L/R button settings.
Press this field to open the TO STEREO/MONO
window.
◆ INPUT DELAY field
This field enables you to view the delay settings.
1
ON indicator
Indicates the on/off status of the delay.
2
Delay time
The delay value is displayed by milliseconds (ms) and also by currently-selected scale. If
the scale uses units of ms, the value in the bottom row will not be displayed. Only the
ms value appears in the middle row.
Press this field to open the INPUT DELAY 8ch window.
◆ HPF field (input channels only)
This field enables you to set the HPF. If an output channel
is selected, a gray circle will appear in location
will not be displayed.
1
HPF knob
Sets the HPF cutoff frequency.
2
ON button
Switches the HPF on or off.
3
1
2
1
2
, and
1
◆ EQ parameter field
This field displays the 4-band EQ parameter settings. Press each
knob to open the HPF/EQ 1ch window.
1
Q knob
Specifies the Q for each band.
If the HIGH band filter type is set to LPF or H.SHELF (high-
shelving), or the LOW band filter type is set to L.SHELF (low-
shelving), the Q knob will not be displayed. Only the filter
type name will be displayed.
NOTE
• Fully rotating the HIGH band Q knob on the panel counter-
clockwise while pressing and holding it down will set the filter
type to LPF. Fully rotating the Q knob clockwise while pressing
and holding it down will set the filter type to high-shelving.
• Fully rotating the LOW band Q knob on the panel clockwise while
pressing and holding it down will set the filter type to low-
shelving.
• If an output channel has been selected, fully rotating the LOW
band Q knob on the panel counter-clockwise while pressing and holding it down will set the filter
type to HPF.
• You can also switch the filter type in the HPF/EQ 1ch window.
2
FREQUENCY knob
2
Sets the center frequency (or cutoff frequency) for each band.
3
GAIN knob
Sets the amount of cut/boost for each band.
NOTE
• If the HIGH band filter type is set to LPF, you can switch LPF on or off using the HIGH band GAIN
knob on the panel.
• If the LOW band filter type is set to HPF, you can switch HPF on or off using the LOW band GAIN
knob on the panel.
9
SELECTED CHANNEL section
1
2
3
Reference Manual
Advertisement
Chapters
Table of Contents
