Installing The Router Chassis In The Rack - Cisco ASR-920-10SZ-PD Installing Manual

Hide thumbs Also See for ASR-920-10SZ-PD:

Table of Contents

Installing the Cisco ASR-920-10SZ-PD Router

Installing the Router Chassis in the Rack

Note

Ensure adequate clearance and air flow when mounting the router in a rack. For more information, see

the Clearance Guidelines section .

Install the cable guides before installing the router in a 19-inch EIA rack. See Attaching the Cable Guides.

Note

To install the router chassis in the equipment rack, perform these steps:

SUMMARY STEPS

1. Insert the rear of the chassis between the mounting posts.

2. Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the equipment

rack.

3. Install the eight 12-24 x 3/4-inch or 10-32 x 3/4-inch zinc-plated steel screws through the holes in the

bracket and into the threaded holes in the equipment rack posts.

4. Use a tape measure and level to verify that the chassis is installed straight and level.

DETAILED STEPS

Step 1

Insert the rear of the chassis between the mounting posts.

Step 2

Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the equipment rack.

The following figure shows how to install the Cisco ASR-920-10SZ-PD Router in a 19-inch EIA rack.

Figure 2: Installing the Chassis in a 19-inch EIA Rack

Cisco ASR 920-10SZ-PD Aggregation Services Router Hardware Installation Guide

Installing the Router Chassis in the Rack

Table of Contents