Table of Contents
Advertisement
9.20 Laser unit
(1) Remove the two taptite bind B M4x12 screws, and remove the top bar. (Models with
520-sheet T1 only)
(2) Disconnect the laser unit flat cable from the laser unit, and release it from the securing
fixtures.
(3) Remove the four taptite cup S M3x8 SR screws, and remove the laser unit.
Note:
• Be careful not to touch the lens of the laser unit.
Taptite cup S M3x8 SR
Laser unit flat cable
Harness routing: Refer to
Assembling Note:
• When attaching the laser unit, tighten the screws in the following order: upper right,
lower right, lower left and upper left.
• When connecting flat cables, do not insert them at an angle. After insertion, check that
the cable is not at an angle.
Taptite bind B M4x12
4
3
Fig. 3-78
"10. Left side of the
Laser unit
1
2
machine",
"11. Rear side of the
3-80
Top bar
(Models with 520-sheet T1 only)
machine".
Confidential
Advertisement
Table of Contents
Troubleshooting
