Dcp Forwarding; Scalance Xb-200/Xc-200/Xp-200 Web Based Management - Siemens SCALANCE XB-200 Configuration Manual
Industrial ethernet switches
Hide thumbs
Also See for SCALANCE XB-200:
- Operating instructions manual (62 pages) ,
- Web based management (190 pages) ,
- Configuration manual (618 pages)
Table of Contents
Advertisement
Configuring with Web Based Management
5.5 The "Layer 2" menu
Changing a link aggregation
1. In the overview, click on the relevant table entry to change the configuration of a created
link aggregation.
2. Make all the changes.
3. Click the "Set Values" button.
5.5.11
DCP forwarding
Applications
The DCP protocol is used by STEP 7 and the Primary Setup Tool (PST) for configuration
and diagnostics. When shipped, DCP is enabled on all ports; in other words, DCP frames
are forwarded at all ports. With this option, you can disable the sending of these frames for
individual ports, for example to prevent individual parts of the network from being configured
with the PST or to divide the full network into smaller subnetworks for configuration and
diagnostics.
All the ports of the device are displayed on this page. After each displayed port, there is a
drop-down list for function selection.
Description of the displayed values
Table 1 has the following columns:
● 1st column
Shows that the settings are valid for all ports of table 2.
● Setting
Select the setting from the drop-down list. If "No Change" is selected, the entry in table 2
remains unchanged.
● Copy to Table
If you click the button, the setting is adopted for all ports of table 2.
214
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
- Quick Links:
- Assignment of an Ip Address
Hide quick links:
Advertisement
Table of Contents
