Configuring The User Interface For Telnet And Ssh - Cisco Catalyst 4500 series Administration Manual
Hide thumbs
Also See for Catalyst 4500 series:
- Software configuration manual (2086 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Chapter 41
Configuring VRF-lite
Command
Step 2
Switch(config)# ip ftp
source-interface interface-type
interface-number
Step 3
Switch(config)# end
To specify the IP address of an interface as the source address for TFTP connections, use the
ip tftp source-interface show mode command. To return to the default, use the no form of this
command.
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# ip tftp
source-interface interface-type
interface-number
Step 3
Switch(config)# end
Configuring the User Interface for Telnet and SSH
To configure VRF-aware for using Telnet and SSH, perform this task:
Command
Switch# telnet ip-address/vrf
vrf-name
Switch# ssh -l username -vrf
vrf-name ip-host
Configuring the User Interface for NTP
To configure VRF-aware for NTP, perform this task:
Command
Switch# ntp server vrf vrf-name
ip-host
Switch# ntp peer vrf vrf-name
ip-host
VRF-lite Configuration Example
The following topology illustrates how to use OSPFv3 for CE-PE routing.
OL_28731-01
Purpose
Specifies the source IP address for FTP connections.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Specifies the source IP address for TFTP connections.
Returns to privileged EXEC mode.
Purpose
Connects through Telnet to an IP host or address in the specified VRF.
Connects through SSH to an IP host or address in the specified VRF.
Purpose
Configure the NTP server in the specified VRF.
Configure the NTP peer in the specified VRF.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Configuring VRF-lite for IPv6
41-17
Advertisement
Chapters
Table of Contents
Troubleshooting
