Using Vlan Maps With Router Acls - Cisco Catalyst 4500 series Administration Manual
Hide thumbs
Also See for Catalyst 4500 series:
- Software configuration manual (2086 pages) ,
- Configuration manual (1610 pages) ,
- Command reference manual (1230 pages)
Table of Contents
Advertisement
Using VLAN Maps with Router ACLs
Using VLAN Maps with Router ACLs
If the VLAN map has a match clause for a packet type (IP or MAC) and the packet does not match the
type, the default is to drop the packet. If there is no match clause in the VLAN map, and no action is
specified, the packet is forwarded if it does not match any VLAN map entry.
You cannot combine VLAN maps or input router ACLs with port ACLs on a switch.
Note
Topics include:
•
•
Guidelines for Using Router ACLs and VLAN Maps on the Same VLAN
Because the switch hardware performs one lookup for each direction (input and output), you must merge
a router ACL and a VLAN map when they are configured on the same VLAN. Merging the router ACL
with the VLAN map can significantly increase the number of ACEs.
When possible, try to write the ACL so that all entries have a single action except for the final, default
action. You should write the ACL using one of these two forms:
permit...
permit...
permit...
deny ip any any
or
deny...
deny...
deny...
permit ip any any
To define multiple permit or deny actions in an ACL, group each action type together to reduce the
number of entries.
If you need to specify the full-flow mode and the ACL contains both IP ACEs and TCP/UDP/ICMP
ACEs with Layer 4 information, put the Layer 4 ACEs at the end of the list. Doing this gives priority to
the filtering of traffic based on IP addresses.
Examples of Router ACLs and VLAN Maps Applied to VLANs
These examples show how router ACLs and VLAN maps are applied on a VLAN to control the access
of switched, bridged, routed, and multicast packets. Although the following illustrations show packets
being forwarded to their destination, each time a packet crosses a line indicating a VLAN map or an
ACL, the packet could be dropped rather than forwarded.
ACLs and Switched Packets
Figure 54-5
within the VLAN are not processed by router ACLs.
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
54-26
Guidelines for Using Router ACLs and VLAN Maps on the Same VLAN, page 54-26
Examples of Router ACLs and VLAN Maps Applied to VLANs, page 54-26
shows how an ACL processes packets that are switched within a VLAN. Packets switched
Chapter 54
Configuring Network Security with ACLs
OL_28731-01
Advertisement
Chapters
Table of Contents
Troubleshooting
