Siemens SINUMERIK 802D sl Programming And Operating Manual page 133
Surface grinding
Hide thumbs
Also See for SINUMERIK 802D sl:
- Function manual (462 pages) ,
- Programming and operating manual (298 pages) ,
- Instruction manual (262 pages)
Table of Contents
Advertisement
The message texts/messages are programmed in the part program using a specified syntax.
The particular syntax is described in the following table:
Table 8- 2
Output
via RS-232-C
Note:
These messages can be saved on the PC in a
file using the tool of a third-party supplier (e.g.
Microsoft® Hyper Terminal).
in a file
Alarm line at the HMI
The MSG text output is defined using the MSG command as well as by appropriately
parameterizing the output interface. For the alarm output, only the output interface has to be
taken into consideration.
If the information line "Processing error MSG command occurred" is output, then the error
protocol can be evaluated under the operating area <SYSTEM> > "Service display" >
"Service control" > "Service MSG" > "Error protocol".
Figure 8-29
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Syntax of the message texts/messages
Dialog box, Service MSG
8.4 SYSTEM - "Service display"
Syntax ("<interface>: Message text")
MSG ("V24: Message text")
MSG ("File: Message text")
MSG ("Alarm text")
System
133
Advertisement
Table of Contents
