Completing The Software Update; Initiating An Srp Switchover; Making Test Calls - Cisco ASR 5500 Administration Manual
Asr 5500 system administration guide, staros release 19
Hide thumbs
Also See for ASR 5500:
- System administration manual (430 pages) ,
- Installation manual (192 pages) ,
- Installation procedure overview (6 pages)
Table of Contents
Advertisement
Primary Chassis
Completing the Software Update
Log into the standby chassis and repeat the following tasks to complete the upgrade process on the standby
primary chassis:
•
•
•
•
•
•
•
•
•
•
Initiating an SRP Switchover
An SRP switchover places the primary chassis in active mode and makes the backup chassis active. The
primary chassis is now processing sessions with the upgraded software.
Step 1
On the backup chassis run the srp initiate-switchover command. All existing sessions will be migrated to the primary
chassis which begins servicing new session requests. Allow the switchover process to complete.
Step 2
On the backup chassis, run the show srp info command. Chassis State should indicate Standby when switchover is
complete.
Step 3
On the primary chassis, confirm the switchover is complete by running the show srp info command. Chassis State should
indicate Active when switchover is complete.
Making Test Calls
Once the chassis state is verified and subscribers are migrated, perform new call testing to make sure calls
are successful.
ASR 5500 System Administration Guide, StarOS Release 19
302
Updating the Boot Record, on page 299
Reloading the Chassis, on page 299
Updating the Configuration File, on page 300
Verifying the Software Version, on page 300
Saving the Configuration File, on page 300
Synchronizing File Systems, on page 299
Performing Health Checks, on page 298
Performing SRP Checks, on page 298
Performing BGP Checks, on page 299
Waiting for Session Synchronization, on page 301
Interchassis Session Recovery
Advertisement
Table of Contents
Troubleshooting
