Configuring Snmp Traps For Rep; Monitoring Rep - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 1
Configuring Resilient Ethernet Protocol
Command
Step 1
rep preempt segment segment-id
Step 2
show rep topology
Configuring SNMP Traps for REP
You can configure the switch to send REP-specific traps to notify the SNMP server of link operational
status changes and port role changes. To configure REP traps, follow these steps, beginning in privileged
EXEC mode:
Command
Step 1
configure terminal
Step 2
snmp mib rep trap-rate value
Step 3
end
Step 4
show running-config
Step 5
copy running-config startup config
To remove the trap, enter the no snmp mib rep trap-rate global configuration command.
This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10
Monitoring REP
Table 1-1
REP Monitoring Commands
Command
show interface [interface-id] rep [detail]
show rep topology [segment segment_id]
[archive] [detail]
OL-25303-03
Purpose
Manually triggers VLAN load balancing on the segment.
You will need to confirm the command before it is executed.
Displays REP topology information.
Purpose
Enters global configuration mode.
Enables the switch to send REP traps, and set the number of
traps sent per second. The range is from 0 to 1000. The default
is 0 (no limit imposed; a trap is sent at every occurrence).
Returns to privileged EXEC mode.
Displays the REP trap configuration.
(Optional) Saves your entries in the switch startup
configuration file.
Purpose
Displays REP configuration and status for an interface or for all interfaces.
•
(Optional) detail—displays interface-specific REP information.
Displays REP topology information for a segment or for all segments,
including the primary and secondary edge ports in the segment.
•
(Optional) archive—displays the last stable topology.
An archive topology is not retained when the switch reloads.
Note
(Optional) detail—displays detailed archived information.
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Monitoring REP
1-13
Advertisement
Table of Contents
Troubleshooting
