Displaying Etherchannel, Pagp, And Lacp Status - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Displaying EtherChannel, PAgP, and LACP Status
Configuring the LACP Port Priority
By default, all ports use the same port priority. If the local system has a lower value for the system
priority and the system ID than the remote system, you can affect which of the hot-standby links become
active first by changing the port priority of LACP EtherChannel ports to a lower value than the default.
The hot-standby ports that have lower port numbers become active in the channel first. You can use the
show etherchannel summary privileged EXEC command to see which ports are in the hot-standby
mode (denoted with an H port-state flag).
Note
If LACP is not able to aggregate all the ports that are compatible (for example, the remote system might
have more restrictive hardware limitations), all the ports that cannot be actively included in the
EtherChannel are put in the hot-standby state and are used only if one of the channeled ports fails.
Beginning in privileged EXEC mode, follow these steps to configure the LACP port priority. This
procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
lacp port-priority priority
Step 4
end
Step 5
show running-config
or
show lacp [channel-group-number]
internal
Step 6
copy running-config startup-config
To return the LACP port priority to the default value, use the no lacp port-priority interface
configuration command.
Displaying EtherChannel, PAgP, and LACP Status
Table 1-4
Commands for Displaying EtherChannel, PAgP , and LACP Status
Command
show etherchannel [channel-group-number {detail |
port | port-channel | protocol | summary}] {detail |
load-balance | port | port-channel | protocol |
summary}
show pagp [channel-group-number] {counters |
internal | neighbor}
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-22
Chapter 1
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration
mode.
Configure the LACP port priority.
For priority, the range is 1 to 65535. The default is 32768. The lower the
value, the more likely that the port will be used for LACP transmission.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Description
Displays EtherChannel information in a brief, detailed, and
one-line summary form. Also displays the load-balance or
frame-distribution scheme, port, port-channel, and protocol
information.
Displays PAgP information such as traffic information, the
internal PAgP configuration, and neighbor information.
Configuring EtherChannels and Link-State Tracking
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
