Table of Contents
Advertisement
TG5230AL.fm Page 75 Friday, June 11, 2004 5:31 PM
If you are satisfied with the operation of your telephone service after plugging in
your Permitted Attachment, your installation is completed.
You will be unable to connect this Permitted Attachment if your telephone service
consists only of a wall phone or an old style telephone which is not connected by
means of a modern plug and socket. In such cases a new socket will need to be
installed.
Should the Permitted Attachment not operate when plugged into a socket, it is
either faulty or unsuitable for operation with your telephone service. It should be
returned to the store where purchased or an Authorised Service Centre.
Service difficulties
If at any time a fault occurs on your telephone service carry out the following checks
before you call for service:
• Disconnect the Permitted Attachment and try using the service, with the normal
telephone.
• If the telephone service then operates satisfactorily, the fault is in your Permitted
Attachment. Leave the Permitted Attachment disconnected and report the fault to
its supplier or agent to arrange for repair.
• If when using the telephone the service is still faulty, report the fault to "Service
Difficulties and Faults" for attention.
You are required to keep this Permitted Attachment in good working order while it is
connected to your telephone service. Its construction or internal circuit must not be
modified in any way without permission.
WARNING
This cordless telephone system does not incorporate provision for secrecy of
conversations. Appropriately tuned radio equipment and other cordless telephone
systems in close proximity may be used by a third party to monitor and possibly
interrupt conversations in progress when this system is on radio operation.
Important Information
75
Advertisement
Chapters
Table of Contents
