Related Manuals for Sealey MIGHTYMIG 150
Summary of Contents for Sealey MIGHTYMIG 150
- Page 1 MIG WELDER INSTRUCTIONS FOR: MIGHTYMIG 150 MODEL NO: Original Language Version MIGHTYMIG150 Issue: 2 - 26/02/10...
- Page 2 It is particularly important to use an RCD together with portable products that are plugged into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You may obtain a Residual Current Device by contacting your Sealey dealer. You must also read and understand the following instructions concerning electrical safety.
- Page 3 GAS SAFETY Store gas cylinders in a vertical position only and ensure the storage area is correctly secured. DO NOT store gas cylinders in areas where the temperature may exceed 50°C. DO NOT use direct heat on a cylinder. Always keep gas cylinders cool. DO NOT attempt to repair or modify any part of a gas cylinder or valve and DO NOT puncture or damage a cylinder.
- Page 4 Obtain the best connection by grinding the point of contact on the workpiece before connecting the clamp. If welding a vehicle, disconnect the battery or fit a “Electronic Circuit Protector” (available from your Sealey dealer). Set up the current switches to give the required power setting and adjust the wire speed accordingly.
- Page 5 An industrial gas cylinder adaptor kit will be required. Contact your local Sealey dealer to order these items. 7.8.1 The following table is an estimated duration of cylinders based on a flow rate of 2 litres per minute.
- Page 6 fig.14 fig.15 9.6. Replacing wire liner: 9.6.1 A worn or damaged wire liner will seriously affect the performance of the welder and should be immediately replaced. First wind the wire back onto the spool and secure it. Remove the four screws securing the torch cable clamp to the wire feed unit (fig.14) and take off the clamp. 9.6.2 To open the torch case first take hold of the locking ring (fig.15-5) and turn it anticlockwise until it stops and then pull it off the two halves of the torch case and slide it a little way down the torch cable.
- Page 7 Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk, email sales@sealey.co.uk or phone 01284 757500. NOTE: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
-
Page 8: Ec Declaration Of Conformity
MIGHTYMIG150 Model/Type:..................................Manufacturing Date / Serial number (optional)......................... Manufacturer's authorised representative within the EC: Jack Sealey Ltd. Kempson Way, Suffolk Business Park, Bury St. Edmunds, Suffolk, IP32 7AR Conforms to the requirements of the following Directives, as indicated. 2006/42/EC Machinery Directive... - Page 9 INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including Sole UK Distributor 01284 757500 www.sealey.co.uk Sealey Group, 01284 703534 sales@sealey.co.uk Bury St. Edmunds, Suffolk. email...