Related Manuals for Sealey SUPERMIG130
Summary of Contents for Sealey SUPERMIG130
- Page 1 INSTRUCTIONS FOR: SUPERMIG WELDER SUPERMIG130 MODEL No: Original Language Version © Jack Sealey Limited SUPERMIG130 Issue No:2(L) 26/08/14...
-
Page 2: Electrical Safety
It is particularly important to use an RCD together with portable products that are plugged into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You may obtain a Residual Current Device by contacting your Sealey dealer. You must also read and understand the following instructions concerning electrical safety. -
Page 3: Gas Safety
3. SPECIFICATION Model No: ..... .SUPERMIG130 Cooling System:..... . Forced Air Welding Current: . -
Page 4: Ratings Plate
Torch: Protect the torch cable assembly from mechanical wear. Clean the liner from the machine forwards by using compressed air. If the liner is blocked it must be replaced. Original Language Version © Jack Sealey Limited SUPERMIG130 Issue No:2(L) 26/08/14... -
Page 5: Troubleshooting
Weld current too high Decrease current and wire speed (Section 5). Weld speed too slow Move torch faster. Incorrect distance of torch to workpiece Torch distance should be 8-10mm. Original Language Version © Jack Sealey Limited SUPERMIG130 Issue No:2(L) 26/08/14... -
Page 6: Environmental Protection
MIG/ARG/100 ..... Disposable 300g Argon Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500. Environmental Protection Recycle unwanted materials instead of disposing of them as waste.