Storage; Cleaning And Storage - Toro 74253 Operator's Manual
With a 60in or 72in turbo force side discharge mower
Hide thumbs
Also See for 74253:
- Setup instructions (13 pages) ,
- Operator's manual (60 pages) ,
- Service manual (272 pages)
Table of Contents
Advertisement
Storage
Cleaning and Storage
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to Off. Remove the
key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine and hydraulic system. Clean dirt and chaff
from the outside of the engine cylinder head fins and
blower housing.
Important: You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use of
water, especially near the control panel, engine,
hydraulic pumps, and motors.
3. Check the brake; refer to Servicing the Brake in
Brake Maintenance , page 44.
4. Service the air cleaner; refer to Servicing the Air
Cleaner in Engine Maintenance , page 31.
5. Grease the machine; refer to Greasing and
Lubrication in Lubrication , page 29.
6. Change the crankcase oil; refer to Servicing the
Engine Oil in Engine Maintenance , page 31.
7. Check the tire pressure; refer to Checking the Tire
Pressure in Drive System Maintenance , page 39.
8. Change the hydraulic filter; refer to Servicing the
Hydraulic System in Hydraulic System Maintenance ,
page 49.
9. Charge the battery; refer to Servicing the Battery in
Electrical System Maintenance , page 36.
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the PTO engaged
and the engine at high idle for 2 to 5 minutes after
washing.
11. Check the condition of the blades; refer to Servicing
the Cutting Blades in Mower Deck Maintenance,
page 53.
12. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for storage
as follows:
A. Add a petroleum based stabilizer/conditioner
to fuel in the tank. Follow mixing instructions
from the stabilizer manufacturer. Do not use an
alcohol based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used
at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the
fuel tank; refer to Servicing the Fuel Tank in Fuel
System Maintenance , page 35.
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned fuel over 90 days.
13. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it out of reach of children or other unauthorized
users. Cover the machine to protect it and keep it
clean.
58
Hide quick links:
Advertisement
Table of Contents
