Table of Contents
Advertisement
Cleaning the Suspension
System
Machines with MyRide™
Suspension System Only
Service Interval: Before each use or daily
Use compressed air to clean the suspension system.
Important:
Do not clean the shock assemblies
with pressurized water.
Figure 96
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
Storage
Cleaning and Storage
Service Interval: Before storage
Before storage
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the P
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove grass clippings, dirt, and grime from
the external parts of the entire machine using
compressed air.
Important:
machine, otherwise you could damage the
g030538
motors and other electric components.
4.
Check the brake; refer to
15).
5.
Grease the machine; refer to
40).
6.
Check the tire pressure; refer to
Tire Pressure (page
7.
Check and tighten all fasteners. Repair or
replace any part that is damaged or missing.
8.
Paint all scratched or bare metal surfaces with
paint from an Authorized Service Dealer.
9.
Store the machine in a clean, dry, garage or
storage area. Remove the key from the switch
and store it in a memorable place. Cover the
machine to protect it and keep it clean.
10.
For prolonged storage, follow the battery
storage requirements; refer to
Requirements (page
55
position.
ARK
Do not use water to clean the
Park Position (page
Lubrication (page
Checking the
43).
Battery Storage
56).
Advertisement
Table of Contents
