Table of Contents
Advertisement
Quick Links
36cm and 41cm Electric Lawn Mowers
Model No. 21136—Serial No. 314000001 and Up
Model No. 21141—Serial No. 314000001 and Up
Safety
Read and understand the contents of this manual before
starting the motor.
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid possible
injury or death.
Improperly using or maintaining this lawn mower could
result in injury or death. To reduce this potential,
comply with the following safety instructions.
WARNING
To reduce the risk of fire, electric shock, and
personal injury when using this electric lawn
mower, always follow these safety instructions.
The following safety information has been adapted from
European Standard EN 60335-77:2010.
Safe Operating Practices
General Information
•
Read the instructions carefully. Be familiar with the
controls and the proper use of the equipment.
•
Never allow children or people unfamiliar with these
instructions to use the machine. Local regulations can
restrict the age of the operator.
•
Never mow while people, especially children or pets, are
nearby.
•
The operator or user is responsible for accidents or
hazards occurring to other people or their property.
Preparation
•
While mowing, always wear substantial footwear and long
trousers. Do not operate the equipment when barefoot
or wearing open sandals.
•
Thoroughly inspect the area where the equipment is to
be used, and remove all objects which can be thrown by
the machine.
•
Before using, always visually inspect to see that the blade,
blade bolts, and cutter assembly are not worn or damaged.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
•
•
•
•
•
Handling
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Register at www.Toro.com.
Replace a worn or damaged blade and bolts as a set to
preserve balance.
Toro recommends that the machine should be supplied
with a residual current device (RCD) having a tripping
current of not more than 30 mA.
2
Use only 1.00 mm
size extension cord no more than
30 m long suitable for outdoor use (if applicable).
Regularly inspect the power cords for signs of damage or
aging. Replace immediately if defective.
Do not use the machine if any power cord is damaged
or worn.
Do not connect a damaged extension cord to the mains
supply or touch a damaged cord before it is disconnected
from the mains supply. A damaged cord can lead to
contact with live parts.
Mow only in daylight or in good artificial light.
Avoid operating the equipment in wet grass, where
feasible.
Always be sure of your footing on slopes.
Walk; never run.
For wheeled rotary mowers, mow across the face of
slopes, never up and down.
Exercise extreme caution when changing direction on
slopes.
Do not mow excessively steep slopes.
Use extreme caution when reversing or pulling the
machine toward you.
Switch off the machine when transporting it from one
cutting area to another. Stop the blade whenever you
move the machine off the lawn.
Never operate the machine with defective guards or
without mounted safety devices (for example, deflectors
and/or grass catchers) in place.
Switch on the motor carefully according to instructions
and with feet well away from the blade.
Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
Never pick up or carry a machine while the motor is
running.
Pull the plug from the socket:
Original Instructions (EN)
All Rights Reserved *3383-532* A
Printed in the UK
Form No. 3383-532 Rev A
Operator's Manual
Advertisement
Table of Contents
Related Manuals for Toro 21136
Summary of Contents for Toro 21136
-
Page 1: Safe Operating Practices
Form No. 3383-532 Rev A 36cm and 41cm Electric Lawn Mowers Model No. 21136—Serial No. 314000001 and Up Model No. 21141—Serial No. 314000001 and Up Operator's Manual Safety Replace a worn or damaged blade and bolts as a set to preserve balance. -
Page 2: Waste Of Electrical/Electronic Equipment (Weee)
• Ensure that only the proper replacement cutting blade is used. Vibration, Hand/arm (Model • Purchase only genuine Toro replacement parts and 21141) accessories. Measured vibration level for right hand = 1.0 m/s Sound Pressure (Model 21136) Measured vibration level for left hand = 0.8 m/s This machine has a sound pressure level at the operator’s ear... -
Page 3: Safety And Instructional Decals
Procedure 1. Height of cut 1. Cut the cable tie around the handle, and remove the cable tie and the packaging material (Model 21136 only). 2. Carefully unfold the handle, keeping the cables clear of the pivot points so that they do not get pinched. -
Page 4: Assembling The Grass Bag
g015106 Figure 2 Model 21141 g015049 3. Tighten the knobs on the handle to secure the handle Figure 3 in place. 1. Grass bag 3. Handle 2. Wire frame 2. Starting at the handle, connect the 6 plastic clips on the grass bag to the wire frame (Figure 4). -
Page 5: Product Overview
2. Extension cord (not 7. Grass bag supplied) 3. Button 8. Rear door 4. Control bar 9. Height-of-cut lever 5. Handle Specifications Model 21136 21141 Weight 20.4 kg 27.4 kg Length 136 cm 138 cm Width 45 cm 48 cm... -
Page 6: Operation
Thoroughly inspect the electrical cord before Figure 9 using the machine. If the cord is damaged, do not operate the machine. Have an Authorized Toro Service Dealer replace or repair a damaged cord 4. While holding in the button, pull the control bar immediately. -
Page 7: Adjusting The Height-Of-Cut Setting
Adjusting the Height-of-Cut Setting DANGER Adjusting the height-of-cut setting could bring your hands and feet into contact with a moving blade and result in serious injury. g015054 Figure 10 Stop the motor and wait for all moving parts to stop before changing the height-of-cut setting. -
Page 8: Bagging The Clippings
Install the grass bag to collect the clippings. 1. Lift the rear door and remove the mulch plug (Figure 14). G019212 Figure 16 Model 21136 shown 1. Mulch plug G01921 1 Mowing Tips Follow these instructions when cutting grass for the best Figure 14 cutting results and lawn appearance. -
Page 9: Maintenance
Maintenance Toro has designed this product to give you years of trouble-free use. Should it need service, bring the product to an Authorized Toro Service Dealer. WARNING When the machine is connected to a household power source, the machine is operational. Someone could accidentally start the machine and cause a serious injury to you or other bystanders. -
Page 10: Servicing The Blade
Servicing the Blade Always mow with a sharp blade. A sharp blade cuts the grass evenly, without tearing or shredding the grass. When you replace the blade, use only genuine Toro replacement blades. WARNING Someone could accidentally start the motor and cause a serious injury to the operator or to bystanders. -
Page 11: Servicing The On/Off And Blade Brake System
Important: Ensure that you do not crimp the the control bar, contact an Authorized Toro Service Dealer. control cables as you fold the handle. This same recommendation applies if you observe heavy vibrations when using the machine. - Page 12 4. Store the machine in a cool, clean, and dry place away from children. 5. Cover the machine to keep it clean and protected.
-
Page 13: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The motor does not start. 1. The extension cord is not connected to 1. Connect the extension cord to the the machine. machine and plug the other end of the extension cord into a normal household outlet. - Page 14 Notes:...
- Page 15 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 16 Authorized Toro Service Dealer. tractor structure that other components such as the engine are secured to, cracks or breaks in normal use, it will be repaired or replaced, at Toro's option, under warranty at no cost for parts General Conditions and labor.