Table of Contents
Advertisement
6
Figure 23
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
1
2
5
4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground.
5. H= height of the trailer or
truck bed to the ground
6. Trailer
Operating Tips
Using the Fast Throttle Setting
For best mowing and maximum air circulation, operate the
engine at the F
grass clippings, so do not set the height-of-cut so low as to
totally surround the mower in uncut grass. Always try to have
1 side of the mower free from uncut grass, which allows air
to be drawn into the mower.
Cutting a Lawn for the First Time
Cut grass slightly longer than normal to ensure that the
cutting height of the mower does not scalp any uneven
ground. However, the cutting height used in the past is
generally the best one to use. When cutting grass longer than
15 cm (6 inches) tall, you may want to cut the lawn twice to
ensure an acceptable quality of cut.
Cutting a Third of the Grass Blade
It is best to cut only about a third of the grass blade. Cutting
more than that is not recommended unless grass is sparse, or
it is late fall when grass grows more slowly.
Alternating the Mowing Direction
g027996
Alternate the mowing direction to keep the grass standing
straight. This also helps disperse clippings which enhances
decomposition and fertilization.
Mowing at Correct Intervals
Grass grows at different rates at different times of the year.
To maintain the same cutting height, mow more often in early
spring. As the grass growth rate slows in mid summer, mow
less frequently. If you cannot mow for an extended period,
first mow at a high cutting height, then mow again 2 days
later at a lower height setting.
Using a Slower Cutting Speed
To improve cut quality, use a slower ground speed in certain
conditions.
Avoiding Cutting Too Low
When mowing uneven turf, raise the cutting height to avoid
scalping the turf.
Cutting Long Grass
If the grass is ever allowed to grow slightly longer than
normal, or if it contains a high degree of moisture, raise the
cutting height higher than usual and cut the grass at this
setting. Then cut the grass again using the lower, normal
setting.
26
position. Air is required to thoroughly cut
AST
Hide quick links:
Advertisement
Table of Contents
