Table of Contents
Advertisement
7. After the engine starts, move the choke lever to off
(Fig. 4). If the engine stalls or hesitates, move the
choke lever back to on for a few seconds. Then move
the throttle lever to desired setting. Repeat this as
required.
2
1
Figure 4
1. PTO—Off
2. Choke–On
3. Choke–Off
1
Figure 5
1. Off
2. Lights
Stopping the Engine
1. Push the PTO (power take off) to off (Fig. 4).
2. Move the throttle lever between half and full throttle
(Fig. 4).
3. Turn the ignition key to off (Fig. 5).
5
3
4
6
m–6523
4. Throttle lever
5. Fast
6. Slow
2
3
4
1208
3. Run
4. Start
Operating the Power Take Off
(PTO)
The power take off (PTO) engages and disengages power
to the electric clutch.
While the ignition key is in run or lights position and the
power take off (PTO) is engaged on, the PTO light, in the
Indicator Module, will be on. When this light is on it is a
reminder; the starter will not crank and to turn the off PTO
before getting off.
Engaging the Power Take Off (PTO)
1. Pull the power take off (PTO) to on (Fig. 6).
1
1. Off—disengaged
Disengaging the Power Take Off (PTO)
1. Push the power take off (PTO) to off (Fig. 6).
The Safety Interlock System
Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
18
2
Figure 6
2. On—engaged
m–6524
Hide quick links:
Advertisement
Table of Contents
