The use of a substitute replacement component which does Leakage 0.5mA current Device not have the same safety characteristics as the PIONEER tester under recommended replacement one, shown in the parts list in test this Service Manual, may create shock, fire, or other hazards.
TS5, BCT-1510, BCT-1520, BCT-1530 2. EXPLODED VIEWS AND PARTS LIST • NOTES: Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List. • mark found on some component parts indicates the importance of the safety factor of the part.
Page 5
BDG1035 Modem Cable (10m:White) See Contrast Table(2) Modem Adapter See Contrast Table(2) Catalogue Bag BHG1047 (2) CONTRAST TABLE TS5/NYXK/FR, TS5/NYXK/FR1, TS5/NYXK/FR2, TS5/NYXK/FR3, BCT-1510/NYXK/SP, BCT-1520/NYXK/IT and BCT-1530/NYWXKPL are constructed the same except for the following: BCT-1510 BCT-1520 BCT-1530 /NYXK/FR /NYXK/SP /NYXK/IT...
Page 7
See Contrast Table (2) Screw BBZ30P080FZK Heat Sink BNH1049 Serial No. Label See Contrast Table (2) (2) CONTRAST TABLE TS5/NYXK/FR, TS5/NYXK/FR1, TS5/NYXK/FR2, TS5/NYXK/FR3, BCT-1510/NYXK/SP, BCT-1520/NYXK/IT and BCT-1530/NYWXKPL are constructed the same except for the following: BCT-1510 BCT-1520 BCT-1530 /NYXK/FR /NYXK/SP /NYXK/IT...
Page 9
TS5, BCT-1510, BCT-1520, BCT-1530 Note : When ordering service parts, be sure to refer to "EXPLODED VIEWS and PARTS LIST" or "PCB PARTS LIST". CN5004 CN6001 0102 BKP1122 BKP1137 0109 REK1102 T2.5A/250V 1110 T6001 BTX1035 5110 6115 5170 7180 7170 +3.3V...
Page 10
TS5, BCT-1510, BCT-1520, BCT-1530 3.2 MAIN ASSY (1/7) DBS Front End Regulator A+28V MAIN ASSY (1/7) CHDEC BLOCK (TS5 : BWE1103) (BCT-1510 : BWE1115) (BCT-1520 : BWE1115) (BCT-1530 : BWE1110) Regulator...
TS5, BCT-1510, BCT-1520, BCT-1530 4. PCB CONNECTION DIAGRAM FRONT ASSY 4.1 FRONT ASSY NOTE FOR PCB DIAGRAMS : SIDE A 1. Part numbers in PCB diagrams match those in the schematic diagrams. 2. A comparison between the main parts of PCB and schematic diagrams is shown below.
Page 29
TS5, BCT-1510, BCT-1520, BCT-1530 4.2 CARD ASSY SIDE A CARD ASSY (BNP1335-C) CN2003...
TS5, BCT-1510, BCT-1520, BCT-1530 5. PCB PARTS LIST Mark No. Description Part No. Mark No. Description Part No. • NOTES: Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List. • mark found on some component parts indicates the importance of the safety factor of the part.
TS5, BCT-1510, BCT-1520, 7. GENERAL INFORMATION BCT-1530 7.1 IC • The information shown in the list is basic information and may not corre- spond exactly to that shown in the schematic diagrams. ¶ List of IC TDA8083H STI5512MWD CXA2161R CS4335-KS 73K324BL-IH AMC2442ACVF(0.87)
Page 38
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (1/3) DESCRIPTION SYMBOL digital I-input bit 2 (ADC bypass) digital I-input bit 3 (ADC bypass) − digital ground 1 (core and input periphery) SSD1 TPLL test pin (normally connected to ground) − digital ground 2 (core and input periphery)
Page 39
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (2/3) DESCRIPTION SYMBOL Ο Power-on Reset − digital supply voltage 4 (output periphery) DDD4 − digital supply voltage 5 (core and input periphery) DDD5 − digital ground 8 (core and input periphery) SSD8 −...
Page 40
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (3/3) SYMBOL DESCRIPTION analog input I − analog ground 2 SSA2 AGC decoupling - Ipath ref(I) − analog supply voltage − supply voltage for crystal oscillator DDXTAL XTALI crystal oscillator input XTALO crystal oscillator output −...
Page 41
TS5, BCT-1510, BCT-1520, BCT-1530 STI5512MWD (MAIN ASSY(2/7) : IC2001) • Programmable Transport IC • Block Diagram Block move ST20 Programmable 2 Kbytes transport instruction interface cache and 2 Kbytes data cache 4 Kbytes IEEE 1394 link layer SRAM interface IEEE 1284...
Page 42
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (1/5) Signal names are prefixed by if they are active low; otherwise they are active high. Number Function Power supply Ground Power supply for clamp diodes VClamp1-3 VDDA0-1 Analog power supply for PAL/NTSC/SECAM encoder...
Page 43
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (2/5) The digital encoder video outputs are analogue signals and are not 5V tolerant. The same applies to the video DAC voltage and current reference pins. 2. The YC0 pin is tri-stated during reset and then sampled at the end of the reset to determine whether the EMI pins are in STi5510 or STi5512 mode.
Page 44
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (3/5) In/Out Function MemAddr2-23 Address bus MemData0-31 in/out Data bus. MemData0 is the least significant bit (LSB) and MemData31 is the most significant bit (MSB). MemRdnotWr ReadnotWrite strobe MemReq Direct memory access request...
Page 45
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (4/5) In/Out Function Low power input clock LPClockIn in/out Low power clock oscillator LPClockOsc AUX_CLK_OUT Auxiliary clock for general use Table 8 Low power controller and real time clock pins 1. The low power clock pins are not 5V tolerant.
Page 46
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (5/5) The teletext clock and data inputs are shared PIO pins, as shown in Table 15 High speed data port pins have a dual function, and can be used either to interface to an external IEEE 1394 link layer controller or provide an IEEE 1284 parallel port interface.
Page 47
TS5, BCT-1510, BCT-1520, BCT-1530 CXA2161R (MAIN ASSY(4/7) : IC4001) • AV Switch • Block Diagram(1/2) Video and Digital section Typical Connection Typical Connection FBLK_SW TV_FBLK FBLK_IN1 FBLK_IN2 VIDEO SWITCH1 (TV) DIG BLUE VIN1 DC Restore Output VOUT1 T.V BLUE VCR BLUE...
Page 49
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (1/3) Symbol Voltage Equivalent Circuit Description VIN_1 VIN_2 RGB signal inputs VIN_4 RGB signal input VIN_3 CVBS signal input 2.35 RGB signal inputs VIN_5 VIN_7 Chrominance signal inputs VIN_6 Chrominance signal inputs VIN_13...
Page 50
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (2/3) Symbol Voltage Equivalent Circuit Description Typically VOUT_7 RF modulator signal output 0.75mA Minimum load = 20k resistive 40.8k Internal reference bias for video circuits. VID_BIAS A capacitor is connected from this pin to GND.
Page 51
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (3/3) Symbol Voltage Equivalent Circuit Description FBLK_IN1 Fast blanking signal inputs FBLK_IN2 TV_FBLK Fast blanking signal output FNC_VCR SCART function pin 8 input / output to 120k FNC_TV SCART function pin 8 output to TV...
TS5, BCT-1510, BCT-1520, BCT-1530 CS4335-KS (MAIN ASSY(4/7) : IC4002) • DAC BLOCK DIAGRAM PIN DESCRIPTIONS Power Supply Connections VA - Analog Power, PIN 7 Analog supply. Nominally +5V. AGND - Analog Ground, PIN 6 Analog ground reference. Analog Outputs AOUTL - Analog Left Cannel Output, PIN 8 Analog output for the left channel.
Page 54
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (1/3) POWER NAME TYPE DESCRIPTION System ground Power supply input, 5 V ±10% (73K324BL). Bypass with 0.1 and 22 µF capacitors to GND. An internally generated reference voltage. Bypass with 0.1 µF VREF capacitor to ground.
Page 55
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (2/3) PARALLEL MICROPROCESSOR INTERFACE (continued) NAME TYPE DESCRIPTION WRITE: A low on this informs the 73K324BL that data is available on AD0-AD7 for writing into an internal register. Data is latched on the rising edge of WR . No data is written unless both WR and the latched CS are low.
Page 56
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function (3/3) DTE USER NAME TYPE DESCRIPTION EXCLK EXTERNAL CLOCK: This signal is used in synchronous transmission when the external timing option has been selected. In the external timing mode the rising edge of EXCLK is used to strobe synchronous DPSK transmit data applied to on the TXD pin.
Page 58
TS5, BCT-1510, BCT-1520, BCT-1530 • Pin Function PIN NUMBER Pin Name I/O TYPE Description Output DTE Data Carrier Detect output signal. Indicates modem has detected carrier. RING Input Ring detector input. This pin assumes that a half wave opto coupler is used in the telephone line DAA circuit in the frequency detection algorithm.
Page 59
TEST For production line RC_MM RC_MM Selection (H : Disabel, L : Enable) pioneer/philips Remote control code selection (H : Philips, L : Pioneer) XHALT Power failure process completion flag (L : Complete, H : Normaly) × For AGC Reading...
TS5, BCT-1510, BCT-1520, BCT-1530 8. PANEL FACILITIES AND SPECIFICATIONS 8.1 PANEL FACILITIES Display of program Several functions keys number or time when Volume terminal is in standby Movement on the Selection of state display program « « Power switch Reader for a bank debit...