Table of Contents
Advertisement
Adjusting the Height of Cut
Note: For heights of cut greater than 1.00" the High
Height of Cut Kit must be installed.
1. Loosen locknuts securing height-of-cut arms to
cutting unit side plates (Figure 21).
Figure 21
1. Height-of-cut arm
2. Locknut
2. Loosen nut on gauge bar (Figure 22) and set
adjusting screw to desired height-of-cut. Distance
between bottom of screw head and face of bar is
height-of-cut.
Figure 22
1. Gauge bar
2. Height adjusting screw
3. Nut
3. Hook the screw head on cutting edge of bedknife
and rest rear end of bar on rear roller (Figure 23).
4. Rotate the adjusting screw until the front roller
contacts the gauge bar (Figure 23). Adjust both ends
of roller until entire roller is parallel to the bedknife.
3. Adjusting screw
4. Holes used for setting
Groomer HOG
5. Hole not used
Important: When set properly, the rear and
front rollers will contact the gauge bar and the
screw will be snug against the bedknife. This
ensures that the height-of-cut is identical at
both ends of the bedknife.
5. Tighten nuts to secure adjustment. Do not
overtighten nut. Tighten enough to remove play
from washer.
Use the following chart to determine which
bedknife is best suited for the desired height of cut.
Bedknife/Height of Cut Chart
Bedknife
Part No.
110-4084
Low HOC
(Optional)
EdgeMaxt®
108-9095
(Production)
Standard
108-9096
(Optional)
HD (Optional)
110-4074
1. Bedknife Lip Height *
15
Figure 23
Bedknife Lip
Height of Cut
Height *
.220"
.250-.375"
.270"
.375-1.50"
.270"
.375-2.0"
.370"
.500-2.0"
Figure 24
Advertisement
Table of Contents
