Chapter 8
Remove Red-Eye
The machine detects eyes in your photos and
will attempt to remove red-eye from your
photo.
Note
There are some cases when red-eye may
not be removed.
• When the face is too small in the
image.
• When the face is turning too far up,
down, left or right.
a
Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press
(PHOTO CAPTURE).
b
Press a or b to choose
Enhance Photos.
Press OK.
c
Press d or c to choose your photo.
Press OK.
d
Press a or b to choose
Remove Red-Eye.
Press OK.
When Remove Red-Eye is
successful, the photo with the effect
is shown. The adjusted part is shown
in a red frame.
When Remove Red-Eye is
unsuccessful,
Unable to Detect. is shown.
Press OK.
Note
Press # to try Remove Red-Eye once
again.
e
Press OK and enter the number of
copies you want using the dial pad.
40
f
Do one of the following:
8
Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 43.)
If you do not want to change any
settings, press Colour Start to print.
Monochrome
You can convert your photo to monochrome.
a
Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press
b
Press a or b to choose
Enhance Photos.
Press OK.
c
Press d or c to choose your photo.
Press OK.
d
Press a or b to choose Monochrome.
Press OK.
e
Press OK and enter the number of
copies you want using the dial pad.
f
Do one of the following:
Press OK and change the print
settings. (See PhotoCapture
Center™ print settings on page 43.)
If you do not want to change any
settings, press Colour Start to print.
Sepia
You can convert the colour of your photo to
sepia.
a
Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press
b
Press a or b to choose
Enhance Photos.
Press OK.
(PHOTO CAPTURE).
(PHOTO CAPTURE).
8
8