Table of Contents Location of controls ..........4 Other Functions Precautions ............5 Adjusting the sound characteristics ....11 Notes on discs ............5 Quickly attenuating the sound ......11 Canceling the beep sound ......... 11 Getting Started Selecting the sound position Resetting the unit ..........
If you have any questions or problems leaving them in parked cars or on concerning your unit that are not covered in dashboards/rear trays. this manual, please consult your nearest Sony dealer. Moisture condensation On a rainy day or in a very damp area, moisture condensation may occur inside the lenses and display of the unit.
•Before playing, clean the discs with a commercially available cleaning cloth. Wipe each disc from the centre out. Do not use Getting Started solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. Resetting the unit Before operating the unit for the first time or after replacing the car battery, you must reset the unit.
Setting the clock CD Player The clock uses a 12-hour digital indication. Example: To set the clock to 10:08 Press (DSPL) for 2 seconds. Playing a disc The hour indication flashes. Insert the disc (labelled side up). 1 Press either side of the volume +/– button to set the hour.
Display items Playing tracks repeatedly — Repeat Play Displayable items The current track will repeat itself when it • Clock reaches the end. • Elapsed playing time Music source During playback, press (3) (REP) until “REP” indicator appears in the display. Repeat Play starts.
Storing stations Radio automatically — Best Tuning Memory (BTM) The unit can store up to 6 stations per band The unit selects the stations with the strongest (FM1, FM2, FM3, AM1, and AM2). signals within the selected band, and stores them in the order of their frequency.
If FM stereo reception is poor Receiving the stored — Monaural Mode stations During radio reception, press (SENS) repeatedly until “MONO” indicator appears. Press (SRC) repeatedly to select the radio. Press (MODE) repeatedly to select the “MONO” indicator is displayed. band.
Canceling the beep sound Other Functions Press (6) while pressing (SEL) down. To activate the beep sound again, press these buttons again. Adjusting the sound Note characteristics If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will You can adjust the bass, treble, balance, and be deactivated.
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may D.BASS-3 be an internal malfunction. In such a case, D.BASS-2 consult your nearest Sony dealer. D.BASS-3 D.BASS-1 D.BASS-2 D.BASS-1 Frequency (Hz)
Insert a flathead screwdriver between Removing the unit the bracket and mounting spring. Gently pry the spring toward the unit while pulling the unit out a little. Repeat on Insert the supplied tool between the unit the opposite side and remove the unit. and the frame, and rotate 90°...
Specifications CD player section Power amplifier section Signal-to-noise ratio 90 dB Outputs Speaker outputs Frequency response 10 – 20,000 Hz (sure seal connectors) Wow and flutter Below measurable limit Speaker impedance 4 – 8 ohms Maximum power output 45 W × 4 (at 4 ohms) Tuner section General Tuning range...
CD playback Troubleshooting A disc cannot be loaded. The following checklist will help you remedy •Another CD is already loaded. problems you may encounter with your unit. •The CD is forcibly inserted upside down or Before going through the checklist below, in the wrong way.
Clean or insert the CD correctly. E-99 The CD unit cannot be operated because of some problem. t Press the reset button on the unit. If these solutions do not help improve the situation, consult your nearest Sony dealer.
取消單聲道模式(第 10 頁)。 出錯顯示 出錯顯示 下述指示將閃爍 一段時間。 E-04 E-04 E-04 E-04 E-04 CD 髒了或 CD 裝反了面。 t 將 CD 擦拭乾淨或正確地裝入 CD。 E-99 E-99 E-99 E-99 E-99 因某些原因 CD 放音機無法工作。 t 按壓復位鍵。 若上述解決方法無助於改善狀況,請向您附 近的 Sony 經銷商諮詢。 Sony Corporation Printed in Korea...