Table of Contents
Advertisement
Quick Links
See also:
User Manual
MultiSync
MultiSync
78133521
NEC Enterprise Series
E
E
900+
900+
User's Manual
Recommended Use 7-8
1
®
®
™
™
1
2-3
4-6
9
10
11
12
13
14-15
5/15/98, 2:16 PM
Advertisement
Table of Contents
Related Manuals for NEC MULTISYNC E900+
Summary of Contents for NEC MULTISYNC E900+
-
Page 1: Table Of Contents
NEC Enterprise Series MultiSync MultiSync User’s Manual User’s Manual Contents Quick Start Controls Recommended Use 7-8 Specifications Features Troubleshooting References Limited Warranty TCO’95 78133521 900+ 900+ 14-15 ® ® ™ ™ 5/15/98, 2:16 PM... - Page 2 TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
-
Page 3: User's Manual
Contents Your new NEC Technologies MultiSync should contain the following: • MultiSync E (JC-1942UMW) Monitor with tilt/swivel base ™ • Power Cord • Captive Signal Cable • User’s Manual • Registration Card Power Cord User’s Manual * Remember to save your original box and packing material to transport or ship the monitor. -
Page 4: Quick Start
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws. NOTE: To obtain the MultiSync E NEC Technologies at (800) 820-1230. 4. For download information on the Windows + monitor, refer to the References section of this User’s Manual. - Page 5 Quick Start Figure B.1 Power Outlet Power Cord Figure C.1 MultiSync E 900+ EXIT PROCEED RESET CONTROL Figure D.1 78133521 5/15/98, 2:16 PM...
-
Page 6: Controls
Controls (On-Screen Manager) control buttons on the front of the monitor function ™ as follows: Main Menu EXIT Exits the OSM menu. Moves the highlighted CONTROL area up/down to select one of the controls. Moves the highlighted CONTROL area left/right to select –/+ one of the controls. -
Page 7: Geometry Controls
Kelvin. If a setting is adjusted, the name of the setting will change from Kelvin to Custom. Red, Green, Blue: NEC's AccuColor Control System decreases or increases the monitor's red, green or blue color guns depending upon which is selected. The change in color will appear on screen and the direction (decrease or increase) will be shown by the bars. -
Page 8: Controls
Adjusting the control bar will change the display’s rotation in a clockwise or counterclockwide direction. Note: NEC recommends that you perform GlobalSync correction while running a typical application such as a spreadsheet or text document. Factory Preset: Selecting Factory Preset allows you a reset most OSM settings back to the factory settings. -
Page 9: Recommended Use
Recommended Use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING THE MULTISYNC • DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may expose you to dangerous shock hazards or other risks. -
Page 10: Recommended Use
• Get regular eye checkups. For more detailed information on setting up a healthy work environment, call NEC at (800) 820-1230, NEC FastFacts document #900108 or write the American National Standard for Human Factors Engineering of Visual Display Terminal Workstations –... -
Page 11: Specifications
1024 x 768 @ 55 to 115 Hz 1152 x 870 @ 55 to 100 Hz 1280 x 1024 @ 55 to 85 Hz ... NEC cites recommended resolution at 1600 x 1200 @ 55 to 75 Hz 356 mm/14.0 inches 267 mm/10.5 inches... -
Page 12: Features
FullScan Capability: Allows you to use the entire screen area in most resolu- ™ tions, significantly expanding image size. OSM Display Screen Copyright 1998 by NEC Technologies, Inc. 78133521 solution with the Windows ® Technology: Reduces magnetic and alternating electric 95 operating system ®... -
Page 13: Troubleshooting
Troubleshooting No picture • Display card should be completely seated in its slot. • Power Button and computer power switch should be in the ON position. • Signal cable should be completely connected to display card/computer. • Check connector for bent or pushed-in pins. Image is scrolling or unstable •... -
Page 14: References
References • BBS NEC Technologies’ Remote Bulletin Board System is an electronic service accessible with your system and a modem. Communication parameters are: 300/1200/2400/9600/14.4k/28.8k bps, no parity, 8-data bits, 1 stop bit • Customer Service/ Technical Support • Electronic Channels: Internet e-mail: tech-support@nectech.com... -
Page 15: Limited Warranty
Limited Warranty NEC Technologies, Inc. (hereinafter “NECTECH”), warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace any part of the enclosed unit which proves defective for a period of three (3) years from the date of first consumer purchase. -
Page 16: Tco'95
TCO’95 Congratulations! You have just purchased a TCO’95 approved and labeled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also, to the further development of environmentally adapted electronics products. -
Page 17: Tco'95
toxins, PCBs, which are suspected to give rise to similar harm, including reproductive damage in fisheating birds and mammals, due to the bio-accumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur. - Page 18 Notes 78133521 5/15/98, 2:16 PM...
- Page 19 + JC-1942UMW Council Directive 73/23/EEC: – EN 60950 Council Directive 89/336/EEC: – EN 55022 – EN 61000-3-2 – EN 61000-3-3 – EN 50082-1 (IEC-801-2) (IEC-801-3) (IEC-801-4) NEC Home Electronics, LTD. 686-1, NISHIOI OI-MACHI, ASHIGARAKAMI-GUN KANAGAWA 258-8533, JAPAN 5/15/98, 2:16 PM...
-
Page 20: Declaration Of Conformity
FCC Rules. MultiSync is a registered trademark of NEC Technologies, Inc. in the U.S. and of NEC Home Electronics, Ltd. in Canada, UK, Germany, France, Spain, Italy, Austria, Benelux, Switzerland, Denmark, Finland, Norway and Saudi Arabia. AccuColor, OptiClear, GlobalSync and ErgoDesign are registered trademarks of NEC Technologies, Inc.