Table of Contents
Advertisement
9.
Intel
P67 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2 [gray])
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
P8P67-M
P8P67-M Intel
• These connectors are set to [AHCI Mode] by default. If you intend to create a Serial ATA
RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID Mode].
See section 2.5.5 SATA Configuration for details.
• Before creating a RAID set, refer to the RAID Supplementary Guide included in the
folder named Manual in the support DVD.
• You must install Windows
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if
you are using Windows
• When using hot-plug and NCQ, set the SATA Mode item in the BIOS to [AHCI Mode].
See section 2.5.5 SATA Configuration for details.
1-29
SATA6G_2
SATA 6.0 Gb/s connectors
®
XP Service Pack 2 or later version before using Serial ATA
®
XP SP2 or later version.
®
SATA6G_1
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
