Inspecting Idling Speed - Yamaha F50F Owner's Manual
Hide thumbs
Also See for F50F:
- Service manual (305 pages) ,
- Owner's manual (110 pages) ,
- Owner's manual (94 pages)
Table of Contents
Advertisement
Maintenance
should replace the spark plug with an-
other of the correct type. WARNING!
When removing or installing a spark
plug, be careful not to damage the in-
sulator. A damaged insulator could
allow external sparks, which could
lead to explosion or fire.
Standard spark plug:
DPR6EB-9
3.
Be sure to use the specified spark plug,
otherwise the engine may not operate
properly. Before fitting the spark plug,
measure the electrode gap with a wire
thickness gauge; adjust the gap to spec-
ification if necessary.
1. Spark plug gap
2. Spark plug I.D. mark (NGK)
3. Spark plug part number
Spark plug gap:
0.8–0.9 mm (0.031–0.035 in)
4.
When fitting the plug, wipe off any dirt
from the threads, and then screw it in to
the correct torque.
Spark plug torque:
18.0 Nm (1.84 kgf-m, 13.3 ft-lb)
72
TIP:
If a torque-wrench is not available when you
are fitting a spark plug, a good estimate of
the correct torque is 1/4 to 1/2 a turn past fin-
ger-tight. Have the spark plug adjusted to the
correct torque as soon as possible with a
torque-wrench.
[EWM00561]
EMU29041
Inspecting idling speed
EWM00451
●
●
ECM00490
NOTICE
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can be
used.
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
outboard motor in the water.
1.
TIP:
Correct idling speed inspection is only possi-
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty ver-
ifying the idle speed, or the idle speed re-
quires adjustment, consult a Yamaha dealer
or other qualified mechanic.
2.
WARNING
Do not touch or remove electrical parts
when starting or during operation.
Keep hands, hair, and clothes away
from the flywheel and other rotating
parts while the engine is running.
Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly.
Verify whether the idle speed is set to
specification. For idle speed specifica-
Advertisement
Table of Contents
