hit counter script

Operation; First-Time Operation; Fill Engine Oil; Breaking In Engine - Yamaha F50F Owner's Manual

Hide thumbs Also See for F50F:
Table of Contents

Advertisement

EMU36380

First-time operation

EMU36390

Fill engine oil

The engine is shipped from the factory with-
out engine oil. If your dealer did not fill the oil,
you must fill it before starting the engine. NO-
TICE: Check that the engine is filled with
oil before first-time operation to avoid se-
vere engine damage.
The engine is shipped with the following
sticker, which should be removed after en-
gine oil is filled for the first time. For more in-
formation on checking the engine oil level,
see page 43.
EMU30174

Breaking in engine

Your new engine requires a period of break-
in to allow mating surfaces of moving parts to
wear in evenly. Correct break-in will help en-
sure proper performance and longer engine
life. NOTICE: Failure to follow the break-in
procedure could result in reduced engine
life or even severe engine damage.
EMU27084
Procedure for 4-stroke models
Your new engine requires a period of 10
hours break-in to allow mating surfaces of
moving parts to wear in evenly. Correct
break-in will help ensure proper performance
and longer engine life.
[ECM01780]
ZMU01710
[ECM00801]
TIP:
Failure to follow the break-in procedure
could result in reduced engine life or even
severe engine damage. Run the engine in
the water, under load (in gear with a propel-
ler installed) as follows. For ten hours for
breaking in engine avoid extended idling,
rough water and crowded areas.
1.
For the first hour of operation:
Run the engine at varying speeds up to
2000 r/min or approximately half throttle.
2.
For the second hour of operation:
Increase engine speed as much as nec-
essary to put the boat on plane (but
avoid full-throttle operation), then back
off on the throttle while keeping the boat
at a planing speed.
3.
Remaining eight hours:
Run the engine at any speed. However,
avoid operating at full throttle for more
than 5 minutes at a time.
4.
After the first 10 hours:
Operate the engine normally.
EMU36400

Getting to know your boat

Different boats handle differently. Operate
cautiously while you learn how your boat
handles under different conditions and with
different trim angles (see page 54).
EMU36412

Checks before starting engine

EWM01920
WARNING
If any item in the checks before starting
engine is not working properly, have it in-
spected and repaired before operating
the outboard motor. Otherwise an acci-
dent could occur.
ECM00120
NOTICE
Do not start the engine out of water. Over-

Operation

41

Advertisement

Table of Contents
loading

This manual is also suitable for:

F60cFt60d

Table of Contents