Table of Contents
Advertisement
6.1
RAID configurations
The system motherboard comes with the NVIDIA CK-04 RAID controller
that allows you to configure Serial ATA hard disk drives as RAID sets. The
motherboard supports the following RAID configurations.
R A I D 0 (Data striping) optimizes two identical hard disk drives to read and
R A I D 0
R A I D 0
R A I D 0
R A I D 0
write data in parallel, interleaved stacks. Two hard disks perform the same
work as a single drive but at a sustained data transfer rate, double that of
a single disk alone, thus improving data access and storage. Use of two
new identical hard disk drives is required for this setup.
R A I D 1
R A I D 1 (Data mirroring) copies and maintains an identical image of data
R A I D 1
R A I D 1
R A I D 1
from one drive to a second drive. If one drive fails, the disk array
management software directs all applications to the surviving drive as it
contains a complete copy of the data in the other drive. This RAID
configuration provides data protection and increases fault tolerance to the
entire system. Use two new drives or use an existing drive and a new drive
for this setup. The new drive must be of the same size or larger than the
existing drive.
R A I D 0 + 1
R A I D 0 + 1
R A I D 0 + 1 is data striping and data mirroring combined without parity
R A I D 0 + 1
R A I D 0 + 1
(redundancy data) having to be calculated and written. With the RAID 0+1
configuration you get all the benefits of both RAID 0 and RAID 1
configurations. Use four new hard disk drives or use an existing drive and
three new drives for this setup.
J B O D
J B O D
J B O D
J B O D
J B O D (Spanning) stands for J u s t a B u n c h o f D i s k s
disk drives that are not yet configured as a RAID set. This configuration
stores the same data redundantly on multiple disks that appear as a single
disk on the operating system. Spanning does not deliver any advantage
over using separate disks independently and does not provide fault
tolerance or other RAID performance benefits.
If you want to boot the system from a hard disk drive included in a
created RAID set, copy first the RAID driver from the support CD to a
floppy disk before you install an operating system to the selected hard
disk drive. Refer to section "6.2 Creating a RAID driver disk" for details.
6 - 2
6 - 2
6 - 2
6 - 2
6 - 2
J u s t a B u n c h o f D i s k s and refers to hard
J u s t a B u n c h o f D i s k s
J u s t a B u n c h o f D i s k s
J u s t a B u n c h o f D i s k s
C h a p t e r 6 : D r i v e r i n s t a l l a t i o n
C h a p t e r 6 : D r i v e r i n s t a l l a t i o n
C h a p t e r 6 : D r i v e r i n s t a l l a t i o n
C h a p t e r 6 : D r i v e r i n s t a l l a t i o n
C h a p t e r 6 : D r i v e r i n s t a l l a t i o n
Advertisement
Table of Contents
